Weslo Pursuit G 3.1 Bike English Manual - Page 10

11. Untie and discard the wire tie on the Reed Switch Wire (33). 11 8 While a second person holds the Console (8) near the Upright (3), connect the wire on the Console to the Reed Switch Wire (33). Insert the excess wire into the Upright (3) or into the Console (8). Tip: Avoid pinching the wires. Attach the Console (8) to the Upright (3) with four M4 x 13mm Truss Screws (42). 33 3 Avoid pinching the wires 42 12. Identify the Right Pedal (12), which is marked with an “"R.”" 12 Using an adjustable wrench, firmly tighten the Right Pedal (12) clockwise into the right side of the Crank (24). Firmly tighten the Left Pedal (not shown) counterclockwise into the left side of the Crank (not shown). Adjust the strap on the Right Pedal (12) to the desired position and press the end of the strap onto the tab on the Right Pedal. Adjust the strap on the Left Pedal (not shown) in the same way. 24 Strap 12 Tab 13. Make sure that all parts are properly tightened before you use the exercise bike. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor. 10