Weslo Pursuit G 3.1 Bike English Manual - Page 14
Maintenance And Troubleshooting
View all Weslo Pursuit G 3.1 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise bike regularly. Replace any worn parts immediately. To clean the exercise bike, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING Most console problems are the result of low batteries. To replace the batteries, see assembly step 10 on page 9. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must remove the left pedal, the resistance knob cover, and the left shield. Using an adjustable wrench, turn the left pedal clockwise and remove it. Press the tabs on the sides of the resistance control and pull the Resistance Knob (14) upward off the resistance control. 14 Tab Tab Locate the Reed Switch (33). Rotate the Pulley (24) until a Magnet (32) is aligned with the Reed Switch. Loosen, but do not remove, the indicated M4 x 19mm Screw (27). Slide the Reed Switch slightly toward or away from the Magnet. 24 32 33 27 Then, retighten the M4 x 19mm Screw (27). Turn the Pulley (24) for a moment. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the left shield, the resistance knob, and the left pedal. See the EXPLODED DRAWING on page 19. Remove the two M3.5 x 19mm Screws (43) and the three M4 x 19mm Screws (27) from the Left Shield (9). Then, remove the Left Shield. 14