Weslo Pursuit G 3.1 Bike English Manual - Page 9
Tip: To prevent the Reed Switch Wire 33
View all Weslo Pursuit G 3.1 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
8. Attach the Water Bottle Holder (13) to the Upright (3) with two M4 x 19mm Screws (27). 8 3 13 27 9. Have a second person hold the Upright (3) near the Frame (1). 9 Wire Tie Locate the wire tie in the Upright (3). Tie the lower end of the wire tie to the Reed Switch Wire (33). Next, pull the upper end of the wire tie upward out of the top of the Upright. Avoid pinching the Reed Switch Wire (33) 3 40 Wire Tie Tip: To prevent the Reed Switch Wire (33) from falling into the Upright (3), secure the Reed Switch Wire with the wire tie. 40 33 Tip: Avoid pinching the Reed Switch Wire (33). Slide the Upright (3) onto the Frame (1). 40 1 Attach the Upright (3) with three M8 x 20mm Screws (40). 10. The Console (8) can use four AA batteries (not included); alkaline batteries are recommended. 10 Do not use old and new batteries together or alkaline, standard, and rechargeable batter- 8 ies together. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before insert- ing batteries. Otherwise, you may damage the console or other electronic components. Remove the battery cover from the back of the Console (8), and insert batteries into the battery compartment. Make sure to orient the batteries as shown by the diagram inside the battery compartment. Then, reattach the battery cover. Battery Compartment 9