Whirlpool DU930PWST Dimensions

Undercounter Dishwasher

®

PRODUCT MODEL NUMBERS

OVERALL DIMENSIONS

CABINET OPENING DIMENSIONS

DU1050XTP

DU1100XTP

DU1101XTP

DU1145XTP

DU1148XTP

DUL240XTP

GU2400XTP

GU2500XTP

GU2548XTP

GU2600XTP

Electrical:

120-volt, 60-Hz, AC-only, 15- or

20-amp. electrical supply. Use copper wire only. A

time-delay fuse or circuit breaker and separate

circuit is recommended.

Water:

A hot water line with 20-120 psi

(138-862 kPa) water pressure. Water temperature

must be 120°F (49°C) at dishwasher. Use 3/8" O.D.

copper tubing with compression fitting or flexible

stainless steel braided fill line (1/2" minimum plastic

tubing is optional but not recommended). Use a 90°

elbow with 3/8" N.P.T. external pipe threads on one

end to connect to water inlet valve. Do not solder

within 6" (15.2 cm) from water inlet valve.

Drain:

Use the new drain hose supplied with your

dishwasher. If this is not suitable, use a new drain

hose with a maximum length of 12 feet (3.7 m)

that meets all current AHAM/IAPMO test

standards, is resistant to heat and detergent, and

fits the drain connector of the dishwasher. Must

have a high drain loop 20 inches (50.8 cm) above

the subfloor or floor. Connect drain hose to waste

tee or disposer inlet above drain trap in house

plumbing and 20 inches (50.8 cm) minimum

above the floor. An air gap must be used if the

drain hose is connected to house plumbing lower

than 20 inches (50.8 cm) above subfloor or floor.

Use 1/2" minimum I.D. drain line fittings.

Corner location:

Requires a 2" (5.1 cm)

minimum clearance between the side of the

dishwasher door and wall or cabinet.

A side panel kit is available from your dealer for

installing your dishwasher at end of cabinet.

Grommet is required for electrical cable or power

supply cord hole cut in a metal cabinet.

Do not install dishwasher over carpeted floor.

Because Whirlpool Corporation policy includes a continuous commitment to improve

our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only.

For complete details, see Installation

Instructions packed with product.

Specifications subject to change without notice.

Ref. 8535437

06-21-04

25" (63,5)

3/4" (1.9 cm)

insulation - may be

compressed (not

used on all models)

24-1/2" (62,2 cm)

21" (53,3 cm)

23-7/8" (60,6 cm)

33-7/8"

(86 cm) min.

with wheels

removed

9"

(22,9 cm)

10"

(25,4 cm)

6-1/4"

(15,9 cm)***

6-1/4"

(15,9 cm)

‡

***

34" (86,4 cm)

min.*

2"

(5,1 cm)

‡

2-1/2"

(6,4 cm)

‡

4"

(10,2 cm)

‡

3"

(7,6 cm)

‡

2"

(5,1 cm)

clear area

‡

4-1/4"

(10,8 cm)

‡

1-3/4"

(4,4 cm)

‡

1-3/4"

(4,4 cm)

‡

24"

(61 cm) min.

24" (61 cm)**

All surfaces must be free

from intrusions

*Measured from the lowest point on the underside of countertop. May be reduced to

33-7/8" (86 cm) by removing wheels from dishwasher.

**Minimum, measured from narrowest point of opening.

***Maybe increased to 6-7/8" (17.5 cm) if height of opening is 34-1/2" (87.6 cm) at lowest

point.

‡

Both sides

Drain hose and power supply line entering through the right

side of opening in shaded areas makes connection easier.

Drain hose size: 1-1/2" (3.8 cm)

Power supply line hole-direct wired: 3/4" (1.9 cm)

Power supply line hole-with plug: 1-1/2" (3.8 cm)

Water line entering through the

left side of opening in shaded

areas makes connection easier.

Minimum 1/2" (12,7 mm) hole.

Whirlpool DU930PWST Dimensions

Whirlpool DU930PWST - on 24 Inch Full Console Dishwasher Manual

Whirlpool DU930PWST manual content summary: