Whirlpool GFE471LVQ Installation Instructions
Whirlpool GFE471LVQ - Ceramic Convection Range Manual
 |
UPC - 883049139043
View all Whirlpool GFE471LVQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool GFE471LVQ manual content summary:
- Whirlpool GFE471LVQ | Installation Instructions - Page 1
30" (76 CM) FREESTANDING ELECTRIC RANGES Table of Contents RANGE SAFETY 1 INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Location Requirements 2 Electrical Requirements 3 INSTALLATION INSTRUCTIONS 4 Unpack Range 4 Install Anti-Tip Bracket 5 Electrical Connection 6 Verify Anti-Tip Bracket - Whirlpool GFE471LVQ | Installation Instructions - Page 2
instructions provided with any tools listed here. Tools needed ■ Tape measure ■ ¼" drive ratchet ■ Flat-blade screwdriver ■ Level ■ Hammer ■ Hand or electric ■ A UL listed power supply cord kit marked for use with ranges. The cord should be rated at 250 volts minimum, 40 amps or 50 amps that is - Whirlpool GFE471LVQ | Installation Instructions - Page 3
range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. A freestanding range a risk of electric shock. Check with a qualified electrician or service technician if you - Whirlpool GFE471LVQ | Installation Instructions - Page 4
be using and follow the instructions provided for it here. ■ Range must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located behind the control panel or on the oven frame behind the storage - Whirlpool GFE471LVQ | Installation Instructions - Page 5
the oven cavity) or from the back of this manual. Depending on the thickness of your flooring, longer screws may be necessary to anchor the bracket to the subfloor. Longer screws are available from your local hardware store. 7. Move range close enough to opening to allow for electrical connections - Whirlpool GFE471LVQ | Installation Instructions - Page 6
grounded outlet. Failure to follow these instructions can result in death, fire, or electrical shock. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper or 6 gauge aluminum wire. Electrically ground range. Failure to follow these instructions can result in death, fire, or - Whirlpool GFE471LVQ | Installation Instructions - Page 7
the ground-link away from the range so that it does not contact the range. A. Removable retaining nut B. Strain relief ■ Tighten strain relief screw against the flexible conduit. 4. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if - Whirlpool GFE471LVQ | Installation Instructions - Page 8
relief screws. 5. Replace terminal block cover. Direct Wire Installation: Copper or Aluminum Wire This range may be connected directly to the circuit breaker box or fused disconnect. Depending on your electrical supply, make the required 3-wire or 4-wire connection. 1. Strip outer covering back - Whirlpool GFE471LVQ | Installation Instructions - Page 9
front of drawer to clear white wheels in drawer guides. Remove drawer and set it aside on a covered electrical connection. 4. Tighten the locking ring of the conduit connector. 5. Replace the terminal block cover. Level Range 1. Place rack in oven. 2. Place level on rack and check levelness of range - Whirlpool GFE471LVQ | Installation Instructions - Page 10
and oven. See the Use and Care Guide for specific instruction on range operation. If range does not operate, check the following: ■ Household fuse is intact and tight; or circuit breaker has not tripped. ■ Range is plugged into an outlet. ■ Electrical supply is connected. ■ See "Troubleshooting" in - Whirlpool GFE471LVQ | Installation Instructions - Page 11
Left edge ANTI-TIP BRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall. Top edge 11 - Whirlpool GFE471LVQ | Installation Instructions - Page 12
W10196158B © 2008. All rights reserved. 8/08 Printed in U.S.A.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
INSTALLATION INSTRUCTIONS
30" (76 CM) FREESTANDING ELECTRIC RANGES
RANGE SAFETY
Table of Contents
RANGE SAFETY
.............................................................................
1
INSTALLATION REQUIREMENTS
................................................
2
Tools and Parts
............................................................................
2
Location Requirements
................................................................
2
Electrical Requirements
..............................................................
3
INSTALLATION INSTRUCTIONS
..................................................
4
Unpack Range
..............................................................................
4
Install Anti-Tip Bracket
.................................................................
5
Electrical Connection
...................................................................
6
Verify Anti-Tip Bracket Location
..................................................
9
Level Range
..................................................................................
9
Complete Installation
.................................................................
10
Moving the Range
......................................................................
10
ANTI-TIP BRACKET TEMPLATE
...............................................
11
IMPORTANT:
Save for local electrical inspector's use.
W10196158B
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death or serious burns to children and adults.