Whirlpool GFG471LVQ Installation Instructions
Whirlpool GFG471LVQ - 30" Gas Range Manual
 |
UPC - 883049139395
View all Whirlpool GFG471LVQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool GFG471LVQ manual content summary:
- Whirlpool GFG471LVQ | Installation Instructions - Page 1
and Parts...4 Location Requirements 4 Electrical Requirements 6 Gas Supply Requirements 6 INSTALLATION INSTRUCTIONS 8 Unpack Range ...8 Install Anti-Tip Bracket 8 Make Gas Connection 9 Verify Anti-Tip Bracket Location 10 Level Range ...11 Electronic Ignition System 11 Replace Oven Racks - Whirlpool GFG471LVQ | Installation Instructions - Page 2
light any appliance. • Do not touch any electrical switch. • Do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. - Installation and service must - Whirlpool GFG471LVQ | Installation Instructions - Page 3
handle type. ■ A flexible gas connector, when used, must not exceed 3 feet. WARNING Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in - Whirlpool GFG471LVQ | Installation Instructions - Page 4
parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed ■ Tape measure ■ Marker or pencil ■ Flat-blade screwdriver ■ Phillips screwdriver ■ Level ■ Hand or electric drill ■ Pipe-joint compound resistant to LP gas The range should be - Whirlpool GFG471LVQ | Installation Instructions - Page 5
installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for 30" (76.2 cm) min. opening width D. For minimum clearance to top of cooktop, see NOTE*. E. 30¹⁄₈" (76.5 cm) min. opening width F. This - Whirlpool GFG471LVQ | Installation Instructions - Page 6
can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier. LP gas conversion: Conversion must be done by a qualified service technician. No attempt shall be made to convert the appliance from the gas specified on the model/serial rating plate - Whirlpool GFG471LVQ | Installation Instructions - Page 7
(1.9 cm) I.D., flexible metal appliance connector may be used for connecting range to the gas supply line. ■ A manual shutoff valve. This valve should be located in the same room but external to the range Gas Supply Pressure Testing Gas supply pressure for testing regulator must be at least 1" water - Whirlpool GFG471LVQ | Installation Instructions - Page 8
INSTALLATION INSTRUCTIONS Unpack Range Install Anti-Tip Bracket WARNING Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. WARNING 1. Remove shipping materials, tape and film from range. 2. Remove oven racks and parts - Whirlpool GFG471LVQ | Installation Instructions - Page 9
in the "Location Requirements" section. 10. Continue installing your range using the following installation instructions. Typical rigid pipe connection A combination of pipe fittings must be used to connect the range to the existing gas line. Your connections may be different, according to the - Whirlpool GFG471LVQ | Installation Instructions - Page 10
will be necessary to view the rear foot from outside the range. A. Gas pressure regulator shutoff valve 2. Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. A B A. Closed valve B. Open valve 3. Test all connections by brushing on - Whirlpool GFG471LVQ | Installation Instructions - Page 11
top burner flames. The cooktop "low" burner flame should be a steady blue flame approximately ¼" (0.64 cm) high. A 3. If range is not level, pull range gas line. If burners do not light properly: ■ Turn cooktop control knob to the "OFF" position. ■ Check that the range size. 3. Replace the control - Whirlpool GFG471LVQ | Installation Instructions - Page 12
to be adjusted, locate the air shutter near the center rear of the range. Loosen the locking screw and rotate the air shutter until the proper flame to light the bake and broil burners. Refer to the Use and Care Guide for proper operation of the oven controls. Adjust Oven Bake Burner Flame (if - Whirlpool GFG471LVQ | Installation Instructions - Page 13
and Care Guide for specific instruction on range operation. If range does not operate, check the following: ■ Household fuse is intact and tight, or circuit breaker has not tripped. ■ Range is plugged into a grounded 3 prong outlet. ■ Electrical supply is connected. ■ See "Troubleshooting" in the - Whirlpool GFG471LVQ | Installation Instructions - Page 14
is moved. Failure to follow these instructions can result in death or serious burns to children and adults. 1. Turn the manual shutoff valve to the closed position. 2. Unplug range or disconnect power. B A C A. To range B. Manual shutoff valve "closed" position C. Gas supply line 14 C Side view - Whirlpool GFG471LVQ | Installation Instructions - Page 15
orifice spud holder located on the back of the range near the gas inlet. Gas orifice spuds are stamped with a number, marked with 1 color dot, and have a groove in the hex area. Replace the Natural gas orifice spud with the correct LP gas orifice spud. A A. Orifice hood B. Pin A A. LP groove Refer - Whirlpool GFG471LVQ | Installation Instructions - Page 16
shutoff valve to the closed position. 2. Unplug range or disconnect power. B A C A. To range B. Manual shutoff valve "closed" position C. Gas supply line To Convert Gas Pressure Regulator 1. Remove storage drawer or warming drawer. See "Replace Oven Racks and Storage or Warming Drawer" section - Whirlpool GFG471LVQ | Installation Instructions - Page 17
on the side. Replace the LP gas orifice spud with the correct Natural gas orifice spud. A LP BFD E NG NG C Side view after A. Plastic cover B. Gas pressure regulator cap with hollow end facing out C. Gas pressure regulator cap with solid end facing out D. Washer E. Gas pressure regulator cap - Whirlpool GFG471LVQ | Installation Instructions - Page 18
Installation 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Refer to the "Electronic important. Natural gas flames do not have yellow tips. 3. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to complete - Whirlpool GFG471LVQ | Installation Instructions - Page 19
Left edge ANTI-TIP BRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall. Top edge 19 - Whirlpool GFG471LVQ | Installation Instructions - Page 20
W10196161D © 2009. All rights reserved. 9/09 Printed in U.S.A.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
INSTALLATION INSTRUCTIONS
30" (76.2 CM) FREESTANDING GAS RANGES
Table of Contents
RANGE SAFETY
...........................................................................................................
2
INSTALLATION REQUIREMENTS
..............................................................................
4
Tools and Parts
..........................................................................................................
4
Location Requirements
..............................................................................................
4
Electrical Requirements
.............................................................................................
6
Gas Supply Requirements
.........................................................................................
6
INSTALLATION INSTRUCTIONS
................................................................................
8
Unpack Range
...........................................................................................................
8
Install Anti-Tip Bracket
..............................................................................................
8
Make Gas Connection
...............................................................................................
9
Verify Anti-Tip Bracket Location
..............................................................................
10
Level Range
.............................................................................................................
11
Electronic Ignition System
.......................................................................................
11
Replace Oven Racks and Warming Drawer
............................................................
13
Storage Drawer
........................................................................................................
13
Complete Installation
...............................................................................................
13
GAS CONVERSIONS
.................................................................................................
14
LP Gas Conversion
..................................................................................................
14
Natural Gas Conversion
...........................................................................................
16
ANTI-TIP BRACKET TEMPLATE
.............................................................................
19
IMPORTANT:
Installer:
Leave installation instructions with the homeowner.
Homeowner:
Keep installation instructions for future reference.
W10196161D