Whirlpool GH5184XPB Installation Instructions
Whirlpool GH5184XPB Manual
 |
View all Whirlpool GH5184XPB manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool GH5184XPB manual content summary:
- Whirlpool GH5184XPB | Installation Instructions - Page 1
of your particular model may differ slightly from the illustration in these installation instructions. Table of Contents MICROWAVE HOOD COMBINATION SAFETY 1 INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Remove Cardboard Template 2 Location Requirements 2 Product Dimensions 3 Electrical - Whirlpool GH5184XPB | Installation Instructions - Page 2
and refer to it during the "Mark Rear Wall" part of installation. Location Requirements Check the opening where the microwave oven will be installed. The location must provide: ■ Minimum installation dimensions. See "Installation Dimensions" illustration. ■ Minimum one 2" x 4" (50.8 x 101.6 mm) wood - Whirlpool GH5184XPB | Installation Instructions - Page 3
for 66" (167.6 cm) installation height. Exact dimensions may vary depending on type of range/cooktop below. Product Dimensions 17¹⁄₄" (43.8 cm) 16¹⁄₂" (42.0 cm) (391.45¹c⁄₂m") 29⁷⁄₈" (76.0 cm) GROUNDING INSTRUCTIONS ■ For all cord connected appliances: The microwave oven must be grounded. In - Whirlpool GH5184XPB | Installation Instructions - Page 4
INSTALLATION INSTRUCTIONS Remove Mounting Plate NOTE: To avoid possible damage to the work surface, cover the work surface. 1. Remove any remaining contents from the microwave oven cavity. 2. Remove the mounting plate and set aside. Rotate Air Deflector The microwave oven is set for recirculation - Whirlpool GH5184XPB | Installation Instructions - Page 5
Venting Installation Only." 4. Rotate air deflector so that deflector feet face the bottom of the microwave oven, and then slide air deflector into the back of the microwave oven as shown, making sure its exhaust port (open end) aligns with the microwave oven exhaust port. A B C A. Microwave oven - Whirlpool GH5184XPB | Installation Instructions - Page 6
wall studs exist within the cabinet opening, do not install the microwave oven. 1. Using a stud finder, locate the edges of A. End holes (on mounting plate) B. Cabinet opening vertical centerline C. Wall stud centerlines D. Holes for lag screws E. Support tabs F. Mounting plate center markers 6 - Whirlpool GH5184XPB | Installation Instructions - Page 7
Rear Wall The microwave oven must be installed on a minimum is damaged or unusable, measure and mark the wall with the dimensions described in Step 4. D A C B A. Rear wall B. ¹⁄₈" (35.9 cm) from the centerline. 5. With the support tabs facing forward (see illustrations in "Locate Wall Stud(s)" - Whirlpool GH5184XPB | Installation Instructions - Page 8
and bolts. Wall Stud at One End Hole (Figure 3) 1. With the support tabs of the mounting plate facing forward, insert a 1/4-20 x 3" round-head bolt through the end hole that fits over the 3/4" (19 mm) hole drilled in Step 3 of "Installation for Wall Stud at One End Hole" in the "Drill Holes in - Whirlpool GH5184XPB | Installation Instructions - Page 9
template has trim lines to use as guides. 4. Make sure the 10 26.5 cm) dimension from the rear wall to points "D" and "E" on the template is maintained. Install the Microwave Oven WARNING Excessive Weight Hazard Use two or more people to move and install microwave oven. Failure to do so can result - Whirlpool GH5184XPB | Installation Instructions - Page 10
circuit breaker has not tripped. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. ■ Check that the power supply cord is plugged into a grounded 3 prong outlet. ■ See the User Instructions for troubleshooting information. Installation is now complete. Save - Whirlpool GH5184XPB | Installation Instructions - Page 11
the top of the microwave oven and the rectangular to round transition piece so that the damper can open freely and fully. ■ We do not recommend using a flexible metal vent. A ■ To avoid possible product damage, be sure to vent air outside, unless using recirculation installation. Do not vent - Whirlpool GH5184XPB | Installation Instructions - Page 12
) wide. Replacement Parts If any of the installation hardware needs to be replaced, call us at our toll free number listed in the User Instructions. Following is a list of available replacement parts. You will need your model number located on the front facing of the microwave oven opening, behind
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
MICROWAVE HOOD COMBINATION
INSTALLATION INSTRUCTIONS
MICROWAVE HOOD COMBINATION SAFETY
This product is suitable for use above electric or gas cooking products up to and including 36" (91.4 cm) wide. See “Installation
Requirements” section for further notes.
These installation instructions cover different models. The appearance of your particular model may differ slightly from the illustration in
these installation instructions.
Table of Contents
MICROWAVE HOOD COMBINATION SAFETY
..............................
1
INSTALLATION REQUIREMENTS
...................................................
2
Tools and Parts
...............................................................................
2
Remove Cardboard Template
........................................................
2
Location Requirements
...................................................................
2
Product Dimensions
.......................................................................
3
Electrical Requirements
..................................................................
3
INSTALLATION INSTRUCTIONS
.....................................................
4
Remove Mounting Plate
.................................................................
4
Rotate Air Deflector
.........................................................................
4
Locate Wall Stud(s)
.........................................................................
6
Mark Rear Wall
................................................................................
7
Drill Holes in Rear Wall
....................................................................
7
Attach Mounting Plate to Wall
........................................................
8
Prepare Upper Cabinet
...................................................................
9
Install the Microwave Oven
............................................................
9
Complete Installation
....................................................................
10
VENTING DESIGN SPECIFICATIONS
............................................
11
ASSISTANCE
...................................................................................
12
Replacement Parts
.......................................................................
12
Accessories
...................................................................................
12
W10217688A
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING