Whirlpool MH1170XSQ Installation Instructions
Whirlpool MH1170XSQ Manual
 |
View all Whirlpool MH1170XSQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool MH1170XSQ manual content summary:
- Whirlpool MH1170XSQ | Installation Instructions - Page 1
notes. These installation instructions cover different models. The appearance of your particular model may differ slightly from the illustration in these installation instructions. Table of Contents MICROWAVE HOOD COMBINATION SAFETY 1 INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Remove Cardboard - Whirlpool MH1170XSQ | Installation Instructions - Page 2
template Mounting plate (attached to back of microwave oven) Cardboard template (part of packaging) Aluminum grease filters Charcoal filters (Depending on model, charcoal filters may not be included. See Use and Care Guide.) NOTE: Depending on model, aluminum grease filter and charcoal filter may - Whirlpool MH1170XSQ | Installation Instructions - Page 3
for 66" (167.6 cm) installation height. Exact dimensions may vary depending on type of range/cooktop below. Product Dimensions 17¹⁄₄" (43.8 cm) 16¹⁄₄" (41.3 cm) (401.05³c⁄₄m") 29⁷⁄₈" (76.0 cm) GROUNDING INSTRUCTIONS ■ For all cord connected appliances: The microwave oven must be grounded. In - Whirlpool MH1170XSQ | Installation Instructions - Page 4
Wall Venting Installation Only 1. Remove screws attaching damper plate to top of microwave oven exterior. Slide damper plate toward the front of the microwave oven and lift up. A B A B A. Mounting plate B. Back of microwave oven 3. Tape the microwave oven door closed so that door does not swing - Whirlpool MH1170XSQ | Installation Instructions - Page 5
to the microwave oven. 7. Reattach damper plate. Make sure damper plate tabs are inserted into the slots in the top of the microwave oven. A B C D A. Damper plate B. Screws C. Damper plate tabs D. Slots 8. Secure damper plate with 2 screws removed in Step 1 of "Wall Venting Installation Only - Whirlpool MH1170XSQ | Installation Instructions - Page 6
studs exist within the cabinet opening, do not install the microwave oven. 1. Using a stud finder, locate the edges F F A. End holes (on mounting plate) B. Cabinet opening vertical centerline C. Wall stud centerlines D. Holes for lag screws E. Support tabs F. Mounting plate center markers 6 - Whirlpool MH1170XSQ | Installation Instructions - Page 7
Mark Rear Wall The microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using a minimum cm) from the centerline. 5. With the support tabs facing forward (see illustrations in "Locate Wall Stud(s)" section, align the mounting plate center markers to the centerline on the wall, - Whirlpool MH1170XSQ | Installation Instructions - Page 8
support tabs of the mounting plate facing forward, insert a 1/4-20 x 3" round-head bolt through the end hole that fits over the 3/4" (19 mm) hole drilled in Step 3 of "Installation upper cabinet align with the holes in the top of the microwave oven. NOTE: If the upper cabinet has a frame around it, - Whirlpool MH1170XSQ | Installation Instructions - Page 9
2. Make sure the microwave oven door is closed and taped shut. 3. Using 2 or more people, lift microwave oven and hang it on support tabs at the bottom of mounting plate. NOTE: To avoid damage to the microwave oven, do not grip or use the door or door handle while the microwave oven is being handled - Whirlpool MH1170XSQ | Installation Instructions - Page 10
between the upper cabinet bottom and the microwave oven. A 2. Connect vent to damper assembly. A B A. Vent B. Damper assembly (under vent) Complete Installation 1. Refer to the Use and Care Guide for instructions on how to install filters into your model. WARNING A. Bolts For Roof Venting - Whirlpool MH1170XSQ | Installation Instructions - Page 11
the top of the microwave oven and the rectangular to round transition piece so that the damper can open freely and fully. ■ We do not recommend using a flexible metal vent. A ■ To avoid possible product damage, be sure to vent air outside, unless using recirculation installation. Do not vent - Whirlpool MH1170XSQ | Installation Instructions - Page 12
and Care Guide. Replacement Parts If any of the installation hardware needs to be replaced, call us at our toll free number listed in the User Instructions. Following is a list of available replacement parts. You will need your model number located on the front facing of the microwave oven opening
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
MICROWAVE HOOD COMBINATION
INSTALLATION INSTRUCTIONS
MICROWAVE HOOD COMBINATION SAFETY
This product is suitable for use above electric or gas cooking products up to and including 36" (91.4 cm) wide. See “Installation
Requirements” section for further notes.
These installation instructions cover different models. The appearance of your particular model may differ slightly from the illustration in
these installation instructions.
Table of Contents
MICROWAVE HOOD COMBINATION SAFETY
..............................
1
INSTALLATION REQUIREMENTS
...................................................
2
Tools and Parts
...............................................................................
2
Remove Cardboard Template
........................................................
2
Location Requirements
...................................................................
2
Product Dimensions
.......................................................................
3
Electrical Requirements
..................................................................
3
INSTALLATION INSTRUCTIONS
.....................................................
4
Remove Mounting Plate
.................................................................
4
Rotate Blower Motor
.......................................................................
4
Locate Wall Stud(s)
.........................................................................
6
Mark Rear Wall
................................................................................
7
Drill Holes in Rear Wall
....................................................................
7
Attach Mounting Plate to Wall
........................................................
8
Prepare Upper Cabinet
...................................................................
8
Install Damper Assembly
................................................................
9
Install the Microwave Oven
............................................................
9
Complete Installation
....................................................................
10
VENTING DESIGN SPECIFICATIONS
............................................
11
ASSISTANCE
...................................................................................
12
Replacement Parts
.......................................................................
12
Accessories
...................................................................................
12
W10191951A
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING