Whirlpool RBS275PRS Installation Instructions

Whirlpool RBS275PRS Manual

Whirlpool RBS275PRS manual content summary:

  • Whirlpool RBS275PRS | Installation Instructions - Page 1
    INSTALLATION INSTRUCTIONS 27" (68.6 CM) ELECTRICSINGLE AND DOUBLE BUILT-IN OVEN INSTRUCTIONS D'INSTALLATION FOUR ELECTRIQUEENCASTRE 27" (68,6 CM) - SIMPLE ETDOUBLE TableofContents / Tabledes mati@res INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Location Requirements 2 Electrical Requirements
  • Whirlpool RBS275PRS | Installation Instructions - Page 2
    " section. • Electrical supply junction box should be located 3" (7.6 cm) maximum below the support surface when the oven is installed in a wall cabinet. Drill a 1" (2.5 cm) minimum diameter hole in the right rear or left rear corner of the support surface to pass the appliance cable through to
  • Whirlpool RBS275PRS | Installation Instructions - Page 3
    cutout to top of cabinet door F. 273/4``(70.5 cm) min. cutout height Product Dimensions - Double Oven A ........... Installation Clearances - Double Oven Double Oven Installed in Cabinet F _D_ E C A. 27" (68.6 cm) min. cabinet width B. 1" (2.5 cm) top of cutout to bottom of upper cabinet door
  • Whirlpool RBS275PRS | Installation Instructions - Page 4
    Electrical Connection To properly install your oven, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. • Oven must be connected to the proper electrical Electrical Connection" section. • Flexible armored cable from appliance
  • Whirlpool RBS275PRS | Installation Instructions - Page 5
    4. Remove bottom screw on each side of the oven trim. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge solid copper wire. Electrically ground oven. Failure to follow these instructions can result in death, fire, or electrical shock. A. Remove trim screw and pull out 5= Grasp
  • Whirlpool RBS275PRS | Installation Instructions - Page 6
    to the neutral (white) junction box wire or when connecting to a 4wire electrical system. A B E C D I A. Cable from power supply B. Red wires C. Green (or bare) ground wires D. 4-wire cable from oven E. Junction box F. White wires G. UL listed wire nuts H. Black wires I. UL listed
  • Whirlpool RBS275PRS | Installation Instructions - Page 7
    shipping feet almost contact cabinet. A. Mounting rail B. insert screw On some models, the oven vent is taped to the side of the oven. See following instructions to install. a}. Insert the vent tabs (B) into slots (A) in the oven frame. b}. With one screw (C) for each side of the vent, fasten vent
  • Whirlpool RBS275PRS | Installation Instructions - Page 8
    (s} does not operate, check the following: • Household fuse is intact and tight; or circuit breaker has not tripped. • Electrical supply is connected. • See "Troubleshooting" section in the Use and Care Guide. 4. When oven has been on for 2 minutes, feel for heat. If you do not feel heat or if an
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

INSTALLATION INSTRUCTIONS
27" (68.6 CM) ELECTRICSINGLE AND DOUBLE
BUILT-IN OVEN
INSTRUCTIONSD'INSTALLATION
FOUR ELECTRIQUEENCASTRE 27" (68,6 CM)
-
SIMPLE ETDOUBLE
Table
of
Contents
/
Tabledes mati@res
INSTALLATION
REQUIREMENTS
..................
2
Tools
and Parts
..............................................
2
Location
Requirements
..................................
2
Electrical
Requirements
.................................
4
INSTALLATION
INSTRUCTIONS
....................
4
Prepare
Oven for Installation
.........................
4
Remove Oven Trim
........................................
4
Make Electrical
Connection
...........................
5
Install Oven
.....................................................
7
Complete
Installation
.....................................
8
SleCURITle
DU
FOUR
ENCASTRle
..................
9
EXIGENCES
D'INSTALLATION
.....................
10
Outillage
et pieces
.......................................
10
Exigences
d'emplacement
..........................
t0
Specifications
_leotriques
............................
t
2
INSTRUCTIONS
D'INSTALLATION
..............
12
Preparation
du four pour I'installation
.........
12
D_pose
des garnitures
du four
....................
12
Raccordement
_lectrique
............................
13
Installation
du four
.......................................
15
Achever
I'installation
....................................
16
BUILT-INOVEN SAFETY
Your
safety
and
the safety
of others
are very
important.
We have provided
many important
safety messages
in this manual and on your appliance.
Always
read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential
hazards that can kill or hurt you and others.
All safety messages
will follow the safety alert symbol and either the word "DANGER"
or "WARNING."
These words mean:
You can be killed or seriously
injured if you don't immediately
follow
instructions.
You can be killed or seriously
injured
if you don't
follow
instructions.
All safety messages
will tell you what the potential
hazard is, tell you how to reduce the chance
of injury, and tell you what can
happen
if the instructions
are not followed.
_MPORTANT:
_nstaHer:
Leave installation
instructions
with the homeowner.
Homeowner:
Keep installation
instructions
for future reference.
Save installation
instructions
for local electrical
inspector's
use.
_MPORTANT
:
_nstaHateur
: Remettre
les instructions
d'installation
au proprietaire.
Proprietaire
: Conserver
les instructions
d'installation
pour reference
ulterieure.
Conserver
les instructions
d'installation
pour consultation
par Hnspecteur
local des installations
electriques.
8303648