Whirlpool RF362LXTB Installation Instructions
Whirlpool RF362LXTB Manual
 |
View all Whirlpool RF362LXTB manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool RF362LXTB manual content summary:
- Whirlpool RF362LXTB | Installation Instructions - Page 1
30" (76 CM) FREESTANDINGELECTRICRANGES TableofContents RANGE SAFETY 1 INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Location Requirements 2 Electrical Requirements 3 INSTALLATION INSTRUCTIONS 4 Unpack Range 4 Install Anti-Tip Bracket 5 Electrical Connection - U.S.A. Only 6 Verify Anti-Tip - Whirlpool RF362LXTB | Installation Instructions - Page 2
INSTALLATIONREQUIREMENTS Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed • Tape measure • Flat-blade screwdriver • Level • Hammer • Hand or electric drill • %" drive ratchet • 1A" nut driver • %" - Whirlpool RF362LXTB | Installation Instructions - Page 3
use with ranges. Electrical Connection To properly install your range, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. • Range must be connected to the proper electrical voltage and frequency as specified on the model/serial - Whirlpool RF362LXTB | Installation Instructions - Page 4
of NEMA Type 10-50R. 3-wire receptacle (10-50R) 4-wire receptacle (14-50R) INSTALLATIONINSTRUCTIONS 1. Remove shipping materials, tape and protective film from range, Remove oven racks and parts package from inside oven. 2. Do not remove the shipping base at this time. A. Shipping base 3, On - Whirlpool RF362LXTB | Installation Instructions - Page 5
range and be killed, Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Faimure to fellow these instructions hardboard from under range. 9. Make electrical connections as described in the "Electrical Connection" section. 10. Move range into its final - Whirlpool RF362LXTB | Installation Instructions - Page 6
grounded outlet. Failure to follow these instructions can result in death, fire, or emectrical shock, Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper or G gauge amuminum wire, EmectricaHy ground range. Failure to follow these instructions can resumt in death, fire, or - Whirlpool RF362LXTB | Installation Instructions - Page 7
the ground-link away from the range so that it does not contact the range. A. Removable retaining nut B. Strain relief • Tighten strain relief screw against the flexible conduit. 4. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if - Whirlpool RF362LXTB | Installation Instructions - Page 8
connector using one of the hex washer head screws. Securely tighten screw for proper electrical connection. In an area where local codes prohibit grounding through the neutral 1. Remove the ground-link screw from the range frame. Save the ground-link screw and cup washer. Bend the ground-link away - Whirlpool RF362LXTB | Installation Instructions - Page 9
clear white wheels in drawer guides. Remove drawer and set floor. • Slide range back so rear range foot is under anti electrical connection. 4. Tighten the locking ring of the conduit connector. 5. Replace the terminal block cover. Place rack in oven. Place level on rack and check levelness of range - Whirlpool RF362LXTB | Installation Instructions - Page 10
an outlet. • Electrical supply is connected. • See "Troubleshooting" in the Use and Care Guide. When the range has been on for 5 minutes, check for heat. If range is cold, turn off the range and contact a qualified technician. Electricam Shock Hazard Disconnect power before servicing, Replace - Whirlpool RF362LXTB | Installation Instructions - Page 11
ANTI-TIPBRACKETTEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall, Top edge Use this template to anchor the left rear leg of range, 11 - Whirlpool RF362LXTB | Installation Instructions - Page 12
9762996A © 2006, All rights reserved. 8/06 Printed in U,S.A,
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
INSTALLATIONINSTRUCTIONS
30"(76 CM) FREESTANDINGELECTRIC
RANGES
TableofContents
RANGE SAFETY
..............................................................................
1
INSTALLATION
REQUIREMENTS
................................................
2
Tools and Parts
............................................................................
2
Location Requirements
................................................................
2
Electrical Requirements
...............................................................
3
INSTALLATION
INSTRUCTIONS
..................................................
4
Unpack
Range
..............................................................................
4
Install Anti-Tip
Bracket
.................................................................
5
Electrical Connection
- U.S.A. Only
.............................................
6
Verify Anti-Tip
Bracket
Location
..................................................
9
Level Range
..................................................................................
9
Complete
Installation
..................................................................
10
Moving the Range
......................................................................
10
ANTI-TIP
BRACKET
TEMPLATE
...............................................
11
RANGE
SAFETY
Your
safety
and
the
safety
of others
are
very
important.
We have provided
many important
safety messages
in this manual and on your appliance.
Always
read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential
hazards that can kill or hurt you and others.
All safety messages
will follow the safety alert symbol and either the word "DANGER"
or "WARNING."
These words mean:
You can be killed or seriously
injured if you don't immediately
follow
instructions.
You can be killed or seriously
injured
if you don't follow
instructions.
All safety messages
will tell you what the potential
hazard is, tell you how to reduce the chance
of injury, and tell you what can
happen
if the instructions
are not followed.
Tip Over
Hazard
A child
or adult
can tip the range
and be killed.
Connect
anti=tip
bracket
to rear range foot.
Reconnect
the antFtip
bracket,
if the
range
is moved.
Failure
to fo(Iow
these
instructions
can
result
in death
or serious
burns
to children
and adults.
(MPORTANT:
Save (nstaUation instructions
for Ioca) e)ectrica( inspector's
use.
9762996A