Whirlpool SF265LXTQ Installation Instructions
Whirlpool SF265LXTQ Manual
 |
View all Whirlpool SF265LXTQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool SF265LXTQ manual content summary:
- Whirlpool SF265LXTQ | Installation Instructions - Page 1
2 Tools and Parts 2 Location Requirements 3 Electrical Requirements 4 Gas Supply Requirements 5 INSTALLATION INSTRUCTIONS 6 Unpack Range 6 Install Anti-Tip Bracket 6 Verify Anti-Tip Bracket Location 7 Level Range 7 Make Gas Connection 7 Electronic Ignition System 8 Replace Oven Racks and - Whirlpool SF265LXTQ | Installation Instructions - Page 2
If using a ball valve, it shall be a T-handle type. s A flexible gas connector, when used, must not exceed 3 feet. INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Parts supplied Read and follow the instructions provided with any tools - Whirlpool SF265LXTQ | Installation Instructions - Page 3
model/serial rating plate. The model/serial rating plate is located on the oven frame behind the storage drawer panel. Product Dimensions Freestanding Range s The range "Electrical Requirements" section. Proper gas supply connection must E be available. See "Gas Supply Requirements" section. s - Whirlpool SF265LXTQ | Installation Instructions - Page 4
than 24" (61 cm), oven frame must extend beyond cabinet fronts range, follow the instructions range is equipped with an electronic ignition range in a clear plastic bag. NOTE: The metal chassis of the range must be grounded in order for the control panel to work. If the metal chassis of the range - Whirlpool SF265LXTQ | Installation Instructions - Page 5
and closing. Do not block access to shutoff valve. The valve is for turning on or shutting off gas to the range. B A C A. Gas supply line B. Shutoff valve "open" position C. To range Gas Pressure Regulator The gas pressure regulator supplied with this range must be used. The inlet pressure to the - Whirlpool SF265LXTQ | Installation Instructions - Page 6
" WCP) or lower The range must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of that system at test pressures equal to or less than ½ psi (3.5 kPa). INSTALLATION INSTRUCTIONS Unpack Range WARNING Excessive Weight Hazard Use - Whirlpool SF265LXTQ | Installation Instructions - Page 7
set it aside on a protected surface. See the Use and Care Guide for the model drawer removal. 2. Making sure the anti-tip bracket is installed: s Look for the anti-tip bracket securely attached to floor. s Slide range back so rear range foot is under anti-tip bracket. Depending on the thickness of - Whirlpool SF265LXTQ | Installation Instructions - Page 8
2. Using a pipe wrench to tighten, connect the gas supply to the range. B C D A F E J A. Gas pressure regulator B. 90° elbow (must have ½" male pipe thread) C. Nipple D. Union E. Black iron pipe I H G F. Manual gas shutoff valve G. ½" or ¾" gas pipe H. Nipple I. Union J. 90° elbow Typical - Whirlpool SF265LXTQ | Installation Instructions - Page 9
up to 50 to 60 seconds to light. Electronic igniters are used to light the bake and broil burners. Refer to the Use and Care Guide for proper operation of the oven controls. Adjust Oven Bake Burner Flame (if needed) 1. On models with a warming drawer, remove access cover plate (1 screw) located - Whirlpool SF265LXTQ | Installation Instructions - Page 10
supply is connected. s See "Troubleshooting" in the Use and Care Guide. 9. When the range has been on for 5 minutes, check for heat. If range is cold, turn off the range and check that the gas supply line shutoff valve is open. s If the gas supply line shutoff valve is closed, open it, then - Whirlpool SF265LXTQ | Installation Instructions - Page 11
to follow these instructions can result in death or serious burns to children and adults. To Convert Gas Pressure Regulator 1. Turn the manual shutoff valve to the closed position. Unplug range or disconnect power. B A C A. To range B. Manual shutoff valve "closed" position C. Gas supply line - Whirlpool SF265LXTQ | Installation Instructions - Page 12
range cooktop to hold the orifice spud holder in place while removing and replacing the orifice spuds. C A D B A. Igniter electrode B. Gas Natural gas: increase gas - increase flame size (preset at factory for Natural gas) D. LP gas: decrease gas - decrease flame size To Convert Oven Broil Burner - Whirlpool SF265LXTQ | Installation Instructions - Page 13
Instructions" section of this manual to complete this procedure. Convert from LP Gas to Natural Gas WARNING To Convert Gas Pressure Regulator 1. Turn the manual shutoff valve to the closed position. Unplug range or disconnect power. B A C A. To range B. Manual shutoff valve "closed" position C. Gas - Whirlpool SF265LXTQ | Installation Instructions - Page 14
Gas Connection" section for properly connecting the range to the gas supply. 2. Refer to the "Electronic Ignition System" section for proper burner ignition Natural gas flames do not have yellow tips. 3. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to - Whirlpool SF265LXTQ | Installation Instructions - Page 15
Notes 15 - Whirlpool SF265LXTQ | Installation Instructions - Page 16
ANTI-TIP BRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall. Top edge Left edge 9762998 © 2005. All rights reserved. 12/05 Printed in U.S.A.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
INSTALLATION INSTRUCTIONS
30" (76 CM) FREESTANDING GAS RANGES
RANGE SAFETY
Table of Contents
RANGE SAFETY
..................................................................
1
INSTALLATION REQUIREMENTS
....................................
2
Tools and Parts
................................................................
2
Location Requirements
....................................................
3
Electrical Requirements
...................................................
4
Gas Supply Requirements
...............................................
5
INSTALLATION INSTRUCTIONS
......................................
6
Unpack Range
.................................................................
6
Install Anti-Tip Bracket
.....................................................
6
Verify Anti-Tip Bracket Location
......................................
7
Level Range
.....................................................................
7
Make Gas Connection
.....................................................
7
Electronic Ignition System
...................................................
8
Replace Oven Racks and Storage or Warming Drawer ... 10
Complete Installation
.........................................................
10
GAS CONVERSIONS
............................................................
11
Convert from Natural Gas to LP Gas
................................
11
Replace Oven Racks and Storage or Warming Drawer ... 13
Complete Installation
.........................................................
13
Convert from LP Gas to Natural Gas
................................
13
Replace Oven Racks and Storage or Warming Drawer ... 14
Complete Installation
.........................................................
14
ANTI-TIP BRACKET TEMPLATE
.......................................
16
IMPORTANT:
Installer:
Leave installation instructions with the homeowner.
Homeowner:
Keep installation instructions for future reference.
Save installation instructions for local electrical inspector's use.
9762998
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death or serious burns to children and adults.