Whirlpool WED5500XW Installation Instructions
Whirlpool WED5500XW Manual
 |
UPC - 883049199917
View all Whirlpool WED5500XW manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WED5500XW manual content summary:
- Whirlpool WED5500XW | Installation Instructions - Page 1
Dryer Installation Instructions 27" Wide Models - U.S.A. Only Para obtener acceso al manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite: www.whirlpool Dryer 16 Complete Installation Checklist 16 Reverse Door Swing (Optional 17 Troubleshooting - Whirlpool WED5500XW | Installation Instructions - Page 2
DRYER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and if you don't immediately follow instructions. WARNING You can be killed or seriously injured if you don't follow instructions. All safety messages will tell - Whirlpool WED5500XW | Installation Instructions - Page 3
metal exhaust system hardware, available for purchase from the dealer from whom you purchased your dryer. For further information, please reference the "Assistance or Service" section of the Dryer User Instructions. If using a power supply cord: Use a UL listed power supply cord kit marked for use - Whirlpool WED5500XW | Installation Instructions - Page 4
. (610 mm) of either side of dryer. See "Electrical Requirements." ■■ A sturdy floor to support the total weight (dryer and load) of 200 lbs. (90.7 . ■■ Additional spacing should be considered for ease of installation and servicing. ■■ Additional clearances might be required for wall, door, and floor - Whirlpool WED5500XW | Installation Instructions - Page 5
of electrical connection you will be using and follow the instructions provided for it here. ■■ If local codes do not permit the connection of a neutral ground wire to the neutral wire, see "Optional 3-wire connection" section. ■■ This dryer is manufactured ready to install with a 3-wire electrical - Whirlpool WED5500XW | Installation Instructions - Page 6
legs into leg holes by hand, use a wrench to finish turning legs until diamond marking is no longer visible. Now stand the dryer on its feet. Slide the dryer until it is close to its final location. Leave enough room for electrical connection and to connect the exhaust vent. To avoid damaging - Whirlpool WED5500XW | Installation Instructions - Page 7
Power Supply Cord Electrical Connection Direct Wire WARNING WARNING Fire Hazard use a new ul listed 30 amp power supply cord. use a ul listed strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire - Whirlpool WED5500XW | Installation Instructions - Page 8
Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point. For 3-wire Power Supply Cord Connection, see page 8. For - Whirlpool WED5500XW | Installation Instructions - Page 9
screw B Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. Remove center, silver-colored terminal block screw (B). 4. Connect - Whirlpool WED5500XW | Installation Instructions - Page 10
(A) onto the strain relief threads. 2. Attach direct wire cable to strain relief (127 5" mm) Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 5" (127 mm) of outer covering from end of cable, leaving bare ground wire at 5" (127 mm). Cut 11/2" (38 - Whirlpool WED5500XW | Installation Instructions - Page 11
block (B). Squeeze hooked ends together and tighten screw. 7. Connect ground wire (893m½m" ) Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 31/2" (89 mm) of outer covering from end of cable. Strip insulation back 1" (25 mm). If using 3-wire cable - Whirlpool WED5500XW | Installation Instructions - Page 12
block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. Optional 3-wire Connection You must verify with a qualified electrician - Whirlpool WED5500XW | Installation Instructions - Page 13
instructions can result in death or fire. WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED OUTDOORS. IMPORTANT: Observe all governing codes and ordinances. Dryer supported in final dryer vents. Review Vent problems and health problems. See "Venting Kits" for more information. 13 - Whirlpool WED5500XW | Installation Instructions - Page 14
best for your installation. Two close-clearance installations are shown. Refer to the manufacturer's instructions. C D E A F G Over-The-Top installation (also available with one offset elbow) B A. Dryer B. Elbow C. Wall D. Exhaust hood E. Clamps I H F. Rigid metal or flexible metal vent G. Vent - Whirlpool WED5500XW | Installation Instructions - Page 15
hood. 2. Connect vent to exhaust hood Vent must fit over the exhaust hood. Secure vent to exhaust hood with 4" (102 mm) clamp. Run vent to dryer location using straightest path possible. Avoid 90° turns. Use clamps to seal all joints. Do not use duct tape, screws, or other fastening devices that - Whirlpool WED5500XW | Installation Instructions - Page 16
is not crushed or kinked. q Check that dryer is level. See "Level Dryer". q Remove film on console and any tape remaining on dryer. q Wipe dryer drum interior thoroughly with a damp cloth to remove any dust. q Read "Dryer Use" in your Use and Care Guide. q Set the dryer on a full heat cycle (not an - Whirlpool WED5500XW | Installation Instructions - Page 17
at top, bottom, and side of door (5 screws). Keep door screws separate from hinge screws as they are different sizes. Holding door over towel on dryer, grasp sides of outer door and lift to separate it from inner door. NOTE: Do not pry apart with putty knife or screwdriver. Do not - Whirlpool WED5500XW | Installation Instructions - Page 18
. 10. Insert screws in hinge holes on dryer cabinet NOTE: 2 people maybe needed to reinstall door. Insert screws into the bottom holes alignment. Troubleshooting See the Use and Care Guide or visit our website and reference Frequently Asked Questions to possibly avoid the 18 cost of a service call. - Whirlpool WED5500XW | Installation Instructions - Page 19
Notes 19 - Whirlpool WED5500XW | Installation Instructions - Page 20
W10096988A W10306460A-SP 2©02010 Whirlpool Corporation. All rights reserved ® Registered Trademark/TM Trademark of Whirlpool, U.S.A. 2/10 Printed in U.S.A.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
W10096988A
W10306460A-SP
DRYER SAFETY
.........................................................................
2
INSTALLATION REQUIREMENTS
.............................................
3
Tools and Parts
......................................................................
3
Location Requirements
.........................................................
3
Electrical Requirements
........................................................
4
Install Leveling Legs
..............................................................
6
Electrical Connection
............................................................
7
VENTING
...................................................................................
13
Venting Requirements
.........................................................
13
Plan Vent System
.................................................................
14
Venting Kits
..........................................................................
14
Install Vent System
..............................................................
15
Connect Vent
........................................................................
15
Level Dryer
...........................................................................
16
Complete Installation Checklist
.........................................
16
Reverse Door Swing (Optional)
..........................................
17
Troubleshooting
...................................................................
18
ELECTRIC DRYER INSTALLATION INSTRUCTIONS
27" WIDE MODELS - U.S.A. ONLY
Para obtener acceso al manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite:
www.whirlpool.com
Tenga listo su número de modelo completo. Puede encontrar el número de modelo y de serie dentro de la cavidad superior de la puerta.
Table of Contents