Whirlpool WED8300SB Use and Care Manual

Whirlpool WED8300SB - Duet Sport Electric Dryer Manual

Get Whirlpool WED8300SB - Duet Sport Electric Dryer PDF manuals and user guides
UPC - 883049064604
View all Whirlpool WED8300SB manuals
Add to My Manuals
Save this manual to your list of manuals

Whirlpool WED8300SB manual content summary:

  • Whirlpool WED8300SB | Use and Care Manual - Page 1
    ELECTRONIC ELECTRIC DRYER For questions about features, operation/performance, accessories or service, call: 1-800-253-1301 or visit our website at... www.whidpooLcom parts, Table of Contents 2 8578899
  • Whirlpool WED8300SB | Use and Care Manual - Page 2
    CONTENTS DRYER SAFETY 3 INSTALLATION INSTRUCTIONS 4 Tools and Parts 4 Optional Pedestal 4 Location Requirements 5 Electrical Requirements 7 Electrical Connection 8 Venting Requirements 13 Plan Vent System 14 Install Vent System 15 Install Leveling Legs 15 Connect Vent 16 Level Dryer 16
  • Whirlpool WED8300SB | Use and Care Manual - Page 3
    We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This replace any part of the dryer or attempt any servicing unless specifically recommended in this Use and Care Guide or in published user-repair instructions that you
  • Whirlpool WED8300SB | Use and Care Manual - Page 4
    rack, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section of this manual. Ask for Part Number 8563738. For more information, see "Drying Rack." Stack Kit Are you planning to stack your DUET SPORT TM washer and dryer? To do so, you will need to purchase
  • Whirlpool WED8300SB | Use and Care Manual - Page 5
    A sturdy floor to support the total dryer weight of 127 Ibs (57.6 kg). The combined weight of a companion appliance should also be considered. A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. (If slope is greater than 1" [2.5 cm], install Extended Dryer Feet Kit, Part No. 279810
  • Whirlpool WED8300SB | Use and Care Manual - Page 6
    or closet installation - Dryer on pedestal Recommended installation spacing for recessed or closet installation, with stacked washer and dryer The dimensions shown are for 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). Mobile
  • Whirlpool WED8300SB | Use and Care Manual - Page 7
    Electrical Connection To properly install your dryer, you must determine the type of electrical connection you will be using and follow the instructions supply cord: Use a UL listed power supply cord kit marked for use with clothes dryers. The kit should contain: [] A UL listed 30-amp power supply
  • Whirlpool WED8300SB | Use and Care Manual - Page 8
    Cord Direct Wire Fire Hazard Use a new UL listed 30 amp power supply cord. Use a UL listed strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected to green
  • Whirlpool WED8300SB | Use and Care Manual - Page 9
    with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable. Electrical Connection Options relief G. Ring terminals 4. Now complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if
  • Whirlpool WED8300SB | Use and Care Manual - Page 10
    of 3-wire connections. Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. Strip 5" (12.7 cm) of outer covering from end of block cover into slot of dryer rear panel. Secure cover with hold-down screw. 7= You have completed your electrical connection. Now go to
  • Whirlpool WED8300SB | Use and Care Manual - Page 11
    screws. !! !! 5. Tighten strain relief screw. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 7. You have completed your electrical connection. Now go to "Venting Requirements." 3-wire connection: Power supply cord Use where local codes
  • Whirlpool WED8300SB | Use and Care Manual - Page 12
    . Tighten screws. !! !! 4. Tighten strain relief screw. 5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 6. You have completed your electrical connection. Now go to "Venting Requirements." Optional 3-wire connection Use for direct wire or power
  • Whirlpool WED8300SB | Use and Care Manual - Page 13
    vent with rigid or flexible heavy metal vent. • Review Vent system chart. Modify existing vent system if vent must be fully extended and supported when the dryer is in its final location. Whirlpool Parts and Accessories. For more information, see the "Assistance or Service" section of this manual
  • Whirlpool WED8300SB | Use and Care Manual - Page 14
    installation NOTE: The following kits for close clearance alternate installations are available for purchase. Please see the "Assistance or Service" section of this manual to order. • Over-the-Top Installation: Part Number 4396028 • Periscope Installation (For use with dryer vent to wall vent
  • Whirlpool WED8300SB | Use and Care Manual - Page 15
    requirements that will help to achieve the best drying performance. Vent system chart NOTE: Side and bottom exhaust installations have a 90 ° turn inside the dryer. To determine maximum exhaust length, add one 90 ° turn to the chart. Number of 90 ° turns or elbows Type of vent Box or Iouvered
  • Whirlpool WED8300SB | Use and Care Manual - Page 16
    opening, if desired. 1. Place a towel or soft cloth on top of the dryer or work space to protect the surface. Remove the door assembly 1. Remove the 4 screws that hold the door hinge on the front panel of the dryer. \ A. Inner ring B. Outer ring 6. Turn inner ring 180 ° and lock
  • Whirlpool WED8300SB | Use and Care Manual - Page 17
    with the 6 screws. A A. Plug strip (cannot be seen from this angle) B. Door strike Reinstall the door 1. Reattach door to dryer front panel with the 4 screws. ® \ A. Dryer front panel B. Door assembly 2. Check for fingerprints on the glass. Clean the glass if necessary. 3. Close door and check
  • Whirlpool WED8300SB | Use and Care Manual - Page 18
    wire installation, reconnect power. 7. Remove the blue protective film on the console and any tape remaining on the dryer. 8. Read "Dryer Use" in the Dryer User Instructions. 9. Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust. 10. Select a Timed Dry heated cycle, and
  • Whirlpool WED8300SB | Use and Care Manual - Page 19
    electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. Follow these basic steps to start your dryer. Please refer to specific sections of this manual showing the final drying time. Fire Hazard No washer can completely remove oil. Do not dry
  • Whirlpool WED8300SB | Use and Care Manual - Page 20
    minute intervals. NOTE: The Timing feature can be used only with Manual Cycles. @® TIMING Press TEMP softener sheet. Follow package instructions. • Remove the load from the dryer as soon as tumbling the Auto or Manual Preset Cycle Settings chart (in the "Cycles" section) for a guide to drying various
  • Whirlpool WED8300SB | Use and Care Manual - Page 21
    on. Wet The WET light will turn on when a wet item has been detected in the dryer. The Wet light will remain on until: • The damp dry point is reached in an Auto and Manual Cycle. Damp The DAMP light indicates that the load has reached the damp dry level. Cool Down
  • Whirlpool WED8300SB | Use and Care Manual - Page 22
    at any time by pressing the WRINKLE SHIELD TM feature button. NOTE: If you do not select the WRINKLE SHIELD TM feature, the dryer stops after the cool down period. Temperature Temperature settings are used with the Manual Cycles. Press TEMP ADJUST until the desired temperature setting illuminates
  • Whirlpool WED8300SB | Use and Care Manual - Page 23
    seconds to lock or unlock this control. NOTE: When the WRINKLE SHIELD TM feature is selected and the End of Cycle Signal is on, an audible sound will , please refer to the front page of your manual or contact the dealer from whom you purchased your dryer. NOTE: The rack must be removed for normal
  • Whirlpool WED8300SB | Use and Care Manual - Page 24
    the lint. See "Venting Requirements." 4. Rinse screen with hot water. 5. Thoroughly dry lint screen with a clean towel. Replace screen in dryer. To clean dryer drum 1. Make a paste with powdered laundry detergent and very warm water. 2. Apply paste to a soft cloth. OR Apply a liquid, nonflammable
  • Whirlpool WED8300SB | Use and Care Manual - Page 25
    servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. For direct-wired dryers: 1. Disconnect power. 2. Disconnect wiring. 3. Make sure leveling legs are secure in dryer base. 4. Use masking tape to secure dryer door. TROUBLESHOOTING
  • Whirlpool WED8300SB | Use and Care Manual - Page 26
    openings at the top and bottom of the door. The front of the dryer requires a minimum of 1" (2.5 cm) of airspace, and, for most installations, the rear of the dryer requires 5" (12.7 cm). See "Installation Instructions." • Has the Air Only modifier been selected? Select the right cycle for the
  • Whirlpool WED8300SB | Use and Care Manual - Page 27
    and service Call the Whirlpool Customer eXperience Center toll free: 1-800-253-1301. Our consultants provide assistance with: • Features and specifications on our full line of appliances • Installation information • Use and maintenance procedures • Accessory and repair parts sales • Specialized
  • Whirlpool WED8300SB | Use and Care Manual - Page 28
    installation of your major appliance, to instruct you how to use your major appliance, to replace or repair house fuses or to correct house wiring or plumbing. 2. Service calls to repair or replace appliance light bulbs, air filters or water filters. Those consumable parts are excluded from warranty
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
ELECTRONIC
ELECTRIC
DRYER
For questions
about features,
operation/performance,
parts,
accessories
or service, call:
1-800-253-1301
or visit our website
at... www.whidpooLcom
Table of Contents
....................................................
2
8578899