Whirlpool WED8300SE Use and Care Manual
Whirlpool WED8300SE - 27in Electric Dryer Manual
 |
UPC - 883049141183
View all Whirlpool WED8300SE manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WED8300SE manual content summary:
- Whirlpool WED8300SE | Use and Care Manual - Page 1
ELECTRONIC ELECTRICDRYER For questions about features, operation/pen%rmance, accessories or service, call: 1-800-253-1301 or visit our website at... www.wbidpooLcom parts, Table of Contents 2 W10151580A - Whirlpool WED8300SE | Use and Care Manual - Page 2
23 Vacation and Moving Care 23 TROUBLESHOOTING 24 ASSISTANCE OR SERVICE 26 ACCESSORIES 26 WARRANTY 28 DRYERSAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety - Whirlpool WED8300SE | Use and Care Manual - Page 3
to the weather. • Do not tamper with controls. • Do not repair or replace any part of the dryer or attempt any servicing unless specifically recommended in this Use and Care Guide or in published user-repair instructions that you understand and have the skills to carry out. • Do not use fabric - Whirlpool WED8300SE | Use and Care Manual - Page 4
rack, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section. Ask for Part Number 8563738. For more information, see "Drying Rack Option." Stack Kit Are you planning to stack your DUET SPORT TM washer and dryer? To do so, you will need to purchase a Stack - Whirlpool WED8300SE | Use and Care Manual - Page 5
servicing. • Additional clearances might be required for wall, door and floor moldings. • Additional spacing should be considered on all sides of the dryer are acceptable. • Companion appliance spacing should also be considered. Custom undercounter installation - Dryer only i'"1"1--'2'"*'°m' -,ilI I1 - Whirlpool WED8300SE | Use and Care Manual - Page 6
spacing is allowed. Recommended installation spacing for recessed or closet installation, with stacked washer and dryer The dimensions shown are for the recommended spacing. 46 in? * {310 cm CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280 - Whirlpool WED8300SE | Use and Care Manual - Page 7
dryer cabinet is isolated from the neutral conductor. A 4-wire power supply connection must be used when the appliance long. GROUNDING INSTRUCTIONS [] For a grounded, cord-connected dryer: This dryer must be grounded. service representative or personnel if you are in doubt as to whether the dryer is - Whirlpool WED8300SE | Use and Care Manual - Page 8
. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point. - Whirlpool WED8300SE | Use and Care Manual - Page 9
. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw permit the use of 3-wire connections. A /¸ 4. Now complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if - Whirlpool WED8300SE | Use and Care Manual - Page 10
3-wire connections. Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. Strip 5" (12.7 cm) of outer covering from end of relief screws. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 7. You have completed - Whirlpool WED8300SE | Use and Care Manual - Page 11
wire Use where local codes permit connecting cabinet-ground conductor to neutral wire. Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. Strip 31/2'' (8.9 cm) of outer covering from end of cable. Strip insulation back 1" (2.5 cm). If using 3-wire cable with - Whirlpool WED8300SE | Use and Care Manual - Page 12
wires to outer terminal block screws. Tighten screws. !! !! 4. Tighten strain relief screw. 5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 6. You have completed your electrical connection. Now go to "Venting Requirements." 4. Tighten strain - Whirlpool WED8300SE | Use and Care Manual - Page 13
instructions can result in death or fire. WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED OUTDOORS. IMPORTANT: Observe all governing codes and ordinances. The dryer Review Whirlpool Parts and Accessories. For more information, see the "Assistance or Service supported when the dryer - Whirlpool WED8300SE | Use and Care Manual - Page 14
clearance installations are shown. Refer to the manufacturer's instructions. T-%;# ly A A. Dryer B. Elbow C. Wall D. Exhaust hood E. Clamps Service" section to order. • Over-the-Top Installation: Part Number 4396028 • Periscope Installation (For use with dryer vent to wall vent mismatch): Part - Whirlpool WED8300SE | Use and Care Manual - Page 15
requirements that will help to achieve the best drying performance. Vent system chart NOTE: Side and bottom exhaust installations have a 90 ° turn inside the dryer. To determine maximum exhaust length, add one 90 ° turn to the chart. Number of 90 ° turns or elbows Type of vent Box or Iouvered - Whirlpool WED8300SE | Use and Care Manual - Page 16
or work space to protect the surface. Remove the door assembly 1. Remove the 4 screws that hold the door hinge on the front panel of the dryer. Reverse hinge 1. Use a small flat-blade screwdriver to remove 2 plug strips from the inner door. Slide the head of the screwdriver under the plugs, being - Whirlpool WED8300SE | Use and Care Manual - Page 17
A. Plug strip (cannot be seen from this angle) B. Door strike Reinstall the door 1. Reattach door to dryer front panel with the 4 screws. 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your - Whirlpool WED8300SE | Use and Care Manual - Page 18
SAFETY INSTRUCTIONS before operating this appliance. Follow these basic steps to start your dryer. Please refer to specific sections of this manual default to the last dryness setting used for that cycle. Fire Hazard No washer can completely remove oil. Do not dry anything that has ever had any - Whirlpool WED8300SE | Use and Care Manual - Page 19
minute intervals. NOTE: The Timing feature can be used only with Manual Cycles. @® rIMING • Press softener sheet. Follow package instructions. • Remove the load from the dryer as soon as tumbling the Auto or Manual Preset Cycle Settings chart (in the "Cycles" section) for a guide to drying various - Whirlpool WED8300SE | Use and Care Manual - Page 20
Feature The WRINKLE SHIELD TM feature to get Low heat for drying no-iron fabrics such as sport shirts, casual business clothes and permanent press blends. Delicate Use items wrinkled from being left in the dryer too long. Manual Preset Cycle Settings Manual Cycles Load Type Temp. Default Time - Whirlpool WED8300SE | Use and Care Manual - Page 21
at any time by pressing the WRINKLE SHIELD TM feature button, NOTE: If you do not select the WRINKLE SHIELD TM feature, the dryer stops after the cool down period. Temperature Temperature settings are used with the Manual Cycles. Press TEMP ADJUST until the desired temperature setting illuminates - Whirlpool WED8300SE | Use and Care Manual - Page 22
or wash screen to remove lint. Wet lint is hard to remove. Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer. Place dryer at least 18 inches (46 cm) above the floor for a garage installation, Failure to do so can result in death, explosion, or fire. 2. Push - Whirlpool WED8300SE | Use and Care Manual - Page 23
screen with hot water. 3. Wet a nylon brush with hot water and liquid detergent. Scrub dryers: 2. Make sure leveling legs are secure in dryer base. 3. Use masking tape to secure dryer door. For direct-wired dryers: Electrical Shock Hazard Disconnect power before servicing. Replace all parts - Whirlpool WED8300SE | Use and Care Manual - Page 24
TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call... In U.S.A. www.whirlpool.com/help - In Canada www.whirlpool.ca Dryer will not run Has a household fuse blown, or has a circuit - Whirlpool WED8300SE | Use and Care Manual - Page 25
airspace, and, for most installations, the rear of the dryer requires 5" (12.7 cm). See "Installation Instructions." Has the Air Only modifier been selected? Select the right temperature for the types of garments being dried. See "Additional Features." Is the load too large and heavy to dry quickly - Whirlpool WED8300SE | Use and Care Manual - Page 26
For assistance and service Call the Whirlpool Customer eXperience Center toll free: 1-800-253-1301. Our consultants provide assistance with: • Features and specifications on our full line of appliances • Installation information • Use and maintenance procedures • Accessory and repair parts sales - Whirlpool WED8300SE | Use and Care Manual - Page 27
27 - Whirlpool WED8300SE | Use and Care Manual - Page 28
installation of your major appliance, to instruct you how to use your major appliance, to replace or repair house fuses or to correct house wiring or plumbing. 2. Service calls to repair or replace appliance light bulbs, air filters or water filters. Those consumable parts are excluded from warranty
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
 |
 |
ELECTRONIC
ELECTRIC
DRYER
For questions
about features,
operation/pen%rmance,
parts,
accessories
or service, call:
1-800-253-1301
or visit our website
at... www.wbidpooLcom
Table of Contents
....................................................
2
W10151580A