Whirlpool WED8300SW Use and Care Guide

Whirlpool WED8300SW - w/ Accents Duet Sport Electric Dryer Manual

Whirlpool WED8300SW manual content summary:

  • Whirlpool WED8300SW | Use and Care Guide - Page 1
    ® ® ELECTRONIC ELECTRIC DRYER Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at... www.whirlpool.com Table of Contents 2 W10151580A
  • Whirlpool WED8300SW | Use and Care Guide - Page 2
    Accumulated Lint 23 Vacation and Moving Care 23 TROUBLESHOOTING 24 ASSISTANCE OR SERVICE 26 ACCESSORIES 26 WARRANTY 28 DRYER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and
  • Whirlpool WED8300SW | Use and Care Guide - Page 3
    be exposed to the weather. ■ Do not tamper with controls. ■ Do not repair or replace any part of the dryer or attempt any servicing unless specifically recommended in this Use and Care Guide or in published user-repair instructions that you understand and have the skills to carry out. ■ Do not use
  • Whirlpool WED8300SW | Use and Care Guide - Page 4
    rack, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section. Ask for Part Number 8563738. For more information, see "Drying Rack Option." Stack Kit Are you planning to stack your DUET SPORT™ washer and dryer? To do so, you will need to purchase a Stack
  • Whirlpool WED8300SW | Use and Care Guide - Page 5
    clearance behind the dryer for the exhaust vent with elbow. See "Venting Requirements." Installation spacing for recessed area or closet installation The following spacing dimensions are recommended for this dryer. This dryer has been tested for spacing of 0" (0 cm) clearance on the sides and rear
  • Whirlpool WED8300SW | Use and Care Guide - Page 6
    72.77 cm) (2.5 cm) (2.5 cm)(68.6 cm) (2.5 cm) *Required spacing **For side or bottom venting, 0" (0 cm) spacing is allowed. Recommended installation spacing for recessed or closet installation, with stacked washer and dryer The dimensions shown are for the recommended spacing. 48 in.2 * (310 cm2
  • Whirlpool WED8300SW | Use and Care Guide - Page 7
    areas where local codes prohibit grounding through the neutral conductors. If using a power supply cord: Use a UL listed power supply cord kit marked for use with clothes dryers. The kit should contain: ■ A UL listed 30-amp power supply cord, rated 120/240 volt minimum. The cord should be type SRD
  • Whirlpool WED8300SW | Use and Care Guide - Page 8
    or electrical shock. Fire Hazard Use 10 gauge solid copper wire. Use a UL listed strain relief. Disconnect power before making electrical connections. relief tab pointing down ■ Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the
  • Whirlpool WED8300SW | Use and Care Guide - Page 9
    screw against the direct wire cable. Electrical Connection Options If your home has: And you will be Go to Section connecting to: 4-wire receptacle (NEMA Type 14-30R) A UL listed, 120/ 240-volt minimum, 30-amp, dryer power supply cord* 4-wire connection: Power supply cord 4-wire direct 5" (12
  • Whirlpool WED8300SW | Use and Care Guide - Page 10
    conductor screw B. Ground wire (green or bare) of power supply cord C 1.9 cm) UL listed strain relief D. Center silver-colored terminal block screw E. block cover into slot of dryer rear panel. Secure cover with hold-down screw. 7. You have completed your electrical connection. Now go to "Venting
  • Whirlpool WED8300SW | Use and Care Guide - Page 11
    D. Neutral wire (white or center wire) E 1.9 cm) UL listed strain relief 3. Connect the other wires to outer terminal block screws. dryer rear panel. Secure cover with hold-down screw. 7. You have completed your electrical connection. Now go to "Venting Requirements." 3-wire connection: Power
  • Whirlpool WED8300SW | Use and Care Guide - Page 12
    3-wire connection Use for direct wire or power supply cord where local codes do not permit (white or center wire) E 1.9 cm) UL listed strain relief 3. Place the hooked ends of the other slot of dryer rear panel. Secure cover with hold-down screw. 6. You have completed your electrical connection.
  • Whirlpool WED8300SW | Use and Care Guide - Page 13
    Do not use a metal foil vent. Failure to follow these instructions can result in death or fire. WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED OUTDOORS. IMPORTANT: Observe all governing codes and ordinances. The dryer exhaust must not be connected into any gas vent, chimney, wall
  • Whirlpool WED8300SW | Use and Care Guide - Page 14
    length necessary to connect elbows H. Exhaust outlet Optional exhaust installations WARNING Fire Hazard Cover unused exhaust holes with the following kit: 279818 (white) Contact your local dealer. Failure to follow these instructions can result in death, fire, electrical shock, or serious injury
  • Whirlpool WED8300SW | Use and Care Guide - Page 15
    longer drying times and increased energy usage. The Vent system chart provides venting requirements that will help to achieve the best drying performance. Vent system chart NOTE: Side and bottom exhaust installations have a 90º turn inside the dryer. To determine maximum exhaust length, add one 90
  • Whirlpool WED8300SW | Use and Care Guide - Page 16
    Reverse Door Swing You can change your door swing from a right-side opening to a left-side opening, if desired. 1. Place a towel or soft cloth on top of the dryer or work space to protect the surface. Remove the door assembly Reverse hinge 1. Use a small flat-blade screwdriver to remove 2 plug
  • Whirlpool WED8300SW | Use and Care Guide - Page 17
    a Timed Dry heated cycle, and start the dryer. Do not select the Air Only modifier. If the dryer will not start, check the following: ■ Controls are set in a running or "On" position. ■ Start button has been pushed firmly. ■ Dryer is plugged into an outlet and/or electrical supply is connected
  • Whirlpool WED8300SW | Use and Care Guide - Page 18
    electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. Follow these basic steps to start your dryer. Please refer to specific sections of this manual used for that cycle. Fire Hazard No washer can completely remove oil. Do not dry anything
  • Whirlpool WED8300SW | Use and Care Guide - Page 19
    If you do not press Start within 5 minutes of selecting a cycle, the dryer automatically shuts off. Drying tips ■ Follow care label directions when they are available. ■ If desired, add a fabric softener sheet. Follow package instructions. ■ Remove the load from the dryer as soon as tumbling stops
  • Whirlpool WED8300SW | Use and Care Guide - Page 20
    Low heat for drying no-iron fabrics such as sport shirts, casual business clothes and permanent press blends. Delicate Use this cycle to get Low heat for load size. Manual Cycles Use Manual Cycles to select a specific amount of drying time and a drying temperature. When a Manual Cycle is selected
  • Whirlpool WED8300SW | Use and Care Guide - Page 21
    , you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for more information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer. NOTE: The rack must be removed for normal tumbling
  • Whirlpool WED8300SW | Use and Care Guide - Page 22
    drying. Refer to the following table. 8. Press (and hold) START button (about 1 second). This chart shows examples of items that heat) Sneakers or canvas shoes Timed Dry Air Only 90 (no heat) *(Minutes) Reset time to complete drying, if needed. DRYER CARE Cleaning the Dryer Location Keep dryer
  • Whirlpool WED8300SW | Use and Care Guide - Page 23
    Wet both sides of lint power supply cord-connected dryers: 1. Unplug the power supply cord. 2. Make sure leveling legs are secure in dryer base. 3. Use masking tape to secure dryer door. For direct-wired dryers: WARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts
  • Whirlpool WED8300SW | Use and Care Guide - Page 24
    and tight, or that both circuit breakers have not tripped. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. ■ Is the correct power supply available? Electric dryers require 240-volt power supply. Check with a qualified electrician. ■ Was a regular fuse
  • Whirlpool WED8300SW | Use and Care Guide - Page 25
    painting, staining or varnishing in the area where your dryer is located? If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry the clothing. ■ Is the dryer being used for the first time? The new electric heating element may have an odor. The odor will be gone
  • Whirlpool WED8300SW | Use and Care Guide - Page 26
    and service Call the Whirlpool Customer eXperience Center toll free: 1-800-253-1301. Our consultants provide assistance with: ■ Features and specifications on our full line of appliances ■ Installation information ■ Use and maintenance procedures ■ Accessory and repair parts sales ■ Specialized
  • Whirlpool WED8300SW | Use and Care Guide - Page 27
    Notes 27
  • Whirlpool WED8300SW | Use and Care Guide - Page 28
    was purchased. ITEMS WHIRLPOOL WILL NOT PAY FOR 1. Service calls to correct the installation of your major appliance, to instruct you how to use your major appliance, to replace or repair house fuses or to correct house wiring or plumbing. 2. Service calls to repair or replace appliance light bulbs
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

ELECTRONIC
ELECTRIC DRYER
Use & Care Guide
For questions about features, operation/performance, parts,
accessories or service, call:
1-800-253-1301
or visit our website at...
www.whirlpool.com
Table of Contents
....................................................
2
W10151580A
®
®