Whirlpool WED8410SW Use and Care Manual

Whirlpool WED8410SW Manual

Whirlpool WED8410SW manual content summary:

  • Whirlpool WED8410SW | Use and Care Manual - Page 1
    ELECTRONIC ELECTRIC DRYER For questions about features, operation/performance, accessories or service, call: 1-800-253-1301 or visit our website at... www.whirlpool.corn parts, Table of Contents 2 W10057250
  • Whirlpool WED8410SW | Use and Care Manual - Page 2
    22 Changing Cycles, Options and Modifiers 23 Drying Rack Option 23 DRYER CARE 24 Cleaning the Dryer Location 24 Cleaning the Lint Screen 24 Cleaning the Dryer Interior 24 Removing Accumulated Lint 25 Vacation and Moving Care 25 TROUBLESHOOTING 25 ASSISTANCE OR SERVICE 27 WARRANTY 28
  • Whirlpool WED8410SW | Use and Care Manual - Page 3
    important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety any part of the dryer or attempt any servicing unless specifically recommended in this Use and Care Guide or in published user-repair instructions that you understand and
  • Whirlpool WED8410SW | Use and Care Manual - Page 4
    installation. Read and follow the instructions provided with any tools listed here dryer or refer to the "Assistance or Service" section of this manual. Ask for Part Number 8563738. For more information, see "Drying Rack Option." Stack Kit Are you planning to stack your DUET SPORT TM washer and dryer
  • Whirlpool WED8410SW | Use and Care Manual - Page 5
    A sturdy floor to support the total dryer weight of 127 Ibs (57.6 kg). The combined weight of a companion appliance should also be considered. A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. (If slope is greater than 1" [2.5 cm], install Extended Dryer Feet Kit, Part No. 279810
  • Whirlpool WED8410SW | Use and Care Manual - Page 6
    installation - Dryer on pedestal Recommended installation spacing for recessed or closet installation, with stacked washer and dryer The dimensions shown 68.6 cm Mobile home - additional installation requirements This dryer is suitable for mobile home installations. The installation must
  • Whirlpool WED8410SW | Use and Care Manual - Page 7
    UL listed power supply cord kit marked for use with clothes dryers. The kit should contain: [] A UL m) long. GROUNDING INSTRUCTIONS [] For a grounded, cord-connected dryer: This dryer must be grounded. In or service representative or personnel if you are in doubt as to whether the dryer is properly
  • Whirlpool WED8410SW | Use and Care Manual - Page 8
    Power Supply Cord Direct Wire Fire Hazard Use a new UL listed 30 amp power supply cord. Use a UL listed strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected
  • Whirlpool WED8410SW | Use and Care Manual - Page 9
    strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten Iisted strain relief G. Ring terminals 4= Now complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire
  • Whirlpool WED8410SW | Use and Care Manual - Page 10
    of 3-wire connections. Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. Strip 5" (12.7 cm) of outer covering from end of relief screws. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 7. You have
  • Whirlpool WED8410SW | Use and Care Manual - Page 11
    wire Use where local codes permit connecting cabinet-ground conductor to neutral wire. Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. Strip 31/2'' (8.9 cm) of outer covering from end of cable. Strip insulation back 1" (2.5 cm). If using 3-wire cable with
  • Whirlpool WED8410SW | Use and Care Manual - Page 12
    wires to outer terminal block screws. Tighten screws. !! !! 4. Tighten strain relief screw. 5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 6. You have completed your electrical connection. Now go to "Venting Requirements." 4. Tighten strain
  • Whirlpool WED8410SW | Use and Care Manual - Page 13
    with rigid or flexible heavy metal vent. • Review Vent system chart. Modify existing vent system Whirlpool Parts and Accessories. For more information, see the "Assistance or Service" section of this manual metal vent must be fully extended and supported when the dryer is in its final location. (10
  • Whirlpool WED8410SW | Use and Care Manual - Page 14
    instructions. /y _i\i / , i,/;" I II "_===J" A. Dryer kits for close clearance alternate installations are available for purchase. Please see the "Assistance or Service" section of this manual to order. • Over-the-Top Installation: Part Number 4396028 • Periscope Installation (For use with dryer
  • Whirlpool WED8410SW | Use and Care Manual - Page 15
    hood. 2. Connect vent to exhaust hood. Vent must fit inside exhaust hood. Secure vent to exhaust hood with 4" (10.2 cm) clamp. 3. Run vent to dryer location. Use the straightest path possible. See "Determine vent path" in "Plan Vent System." Avoid 90 ° turns. Use clamps to seal all joints. Do not
  • Whirlpool WED8410SW | Use and Care Manual - Page 16
    and inside the exhaust hood. Check that the vent is secured to exhaust hood with a 4" (10.2 cm) clamp. 2. Move dryer into its final location. Do not crush or kink vent. 3. (On gas models) Check that there are no kinks in the flexible gas line. 4. Once the exhaust vent connection is made, remove
  • Whirlpool WED8410SW | Use and Care Manual - Page 17
    to the other side. Reinstall the 4 screws. A A. Plug strip (cannot be seen from this angle) B. Door strike Reinstall the door 1. Reattach door to dryer front panel with the 4 screws. A. Door hinge 4. Reinstall plug strips on opposite side of the inner door. 5. Check for fingerprints on the glass
  • Whirlpool WED8410SW | Use and Care Manual - Page 18
    an outlet. For direct wire installation, reconnect power. 7. Remove the blue protective film on the console and any tape remaining on the dryer. 8. Read "Dryer Use." 9. Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust. 10. Select a Timed Dry heated cycle, and start the
  • Whirlpool WED8410SW | Use and Care Manual - Page 19
    of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. Follow these basic steps to start your dryer. Please refer to specific sections of this manual for more detailed information. f. Clean lint screen before each load. See "Cleaning
  • Whirlpool WED8410SW | Use and Care Manual - Page 20
    desired, add a fabric softener sheet. Follow package instructions. • Remove the load from the dryer as soon as tumbling stops to reduce wrinkling. settings. • Refer to the Auto or Manual Preset Cycle Settings chart (in the "Cycles" section) for a guide to drying various loads. Drying temperature and
  • Whirlpool WED8410SW | Use and Care Manual - Page 21
    has been detected in the dryer. The Wet light will remain on until: • The damp dry point is reached in an Auto or Manual Cycle. Damp The DAMP light this cycle to get Low heat for drying no-iron fabrics such as sport shirts, casual business clothes and permanent press blends. Delicate Use this cycle
  • Whirlpool WED8410SW | Use and Care Manual - Page 22
    smooth out wrinkles from such items as clothes packed in a suitcase or items wrinkled from being left in the dryer too long. Manual Preset Cycle Settings Manual Cycles Load Type Temp. Default Time (Minutes) TIMED DRY High* 40 Heavyweight, bulky items, bedspreads, work clothes QUICK DRY
  • Whirlpool WED8410SW | Use and Care Manual - Page 23
    , you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for more information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer. NOTE: The rack must be removed for normal tumbling
  • Whirlpool WED8410SW | Use and Care Manual - Page 24
    items that would obstruct the flow of combustion and ventilation air. Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer. Place dryer at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire
  • Whirlpool WED8410SW | Use and Care Manual - Page 25
    dryer base. 4. Use masking tape to secure dryer door. TROUBLESHOOTING First try the solutions suggested here and possibly avoid the cost of a service call... Dryer is the dryer level front to back and side to side? The dryer may vibrate if not properly installed. See "Installation Instructions." •
  • Whirlpool WED8410SW | Use and Care Manual - Page 26
    openings at the top and bottom of the door. The front of the dryer requires a minimum of 1" (2.5 cm) of airspace, and, for most installations, the rear of the dryer requires 5" (12.7 cm). See "Installation Instructions." • Has the Air Only modifier been selected? Select the right temperature for the
  • Whirlpool WED8410SW | Use and Care Manual - Page 27
    Before calling for assistance or service, please check "Troubleshooting." It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance. This information
  • Whirlpool WED8410SW | Use and Care Manual - Page 28
    accordance with published installation instructions. 11. Replacement parts warranty does not apply. Contact your authorized Whirlpool dealer to determine if another warranty applies. If you need service, first see the "Troubleshooting" section of the Use & Care Guide. After checking "Troubleshooting
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

ELECTRONIC
ELECTRIC
DRYER
For questions
about
features,
operation/performance,
parts,
accessories
or service,
call:
1-800-253-1301
or visit our website
at... www.whirlpool.corn
Table
of Contents
....................................................
2
W10057250