Whirlpool WED94HEAC Ventilation Specification
Whirlpool WED94HEAC Manual
View all Whirlpool WED94HEAC manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WED94HEAC manual content summary:
- Whirlpool WED94HEAC | Ventilation Specification - Page 1
AND CLEANING 7 Frequency of Exhaust System Cleaning 7 Inspecting the Exhaust System ...7 DRYER SAFETY ■ If you are installing a gas dryer, it is recommended that the owner post, in a prominent location, instructions for the customer's use in the event the customer smells gas. This information - Whirlpool WED94HEAC | Ventilation Specification - Page 2
2 - Whirlpool WED94HEAC | Ventilation Specification - Page 3
3 - Whirlpool WED94HEAC | Ventilation Specification - Page 4
the dryer's vent pipe, for use in the design of dryer vent systems. Whirlpool does not design multidryer vent systems, nor does Whirlpool review or combustible surfaces cannot be met. See the Installation Instructions for the specific dryer model being used or considered for spacing requirements. - Whirlpool WED94HEAC | Ventilation Specification - Page 5
ft (1.83 m). For example, if the Installation Instructions state that a dryer is allowed 40 ft (12.2 m) of or on the Whirlpool.com website. The exhaust airflow of any Whirlpool produced dryer at the be considered for ease of installation and servicing. ■ Additional clearances might be required for - Whirlpool WED94HEAC | Ventilation Specification - Page 6
using. Refer to the "Plan Vent System" section of the Use and Care Guide for details. ■ Select a Timed Dry heated cycle, and restart the dryer. ■ If the message persists, have your entire home venting run cleaned. For multi-dryer venting systems, the "AF" code means that your vent may be blocked or - Whirlpool WED94HEAC | Ventilation Specification - Page 7
the exhaust hood, check that the flapper or louvers move freely. 3. Reassemble the exhaust duct and hood, checking that the joints are secure. 4. Operate the dryer and verify that the exhaust air is not obstructed in the vent and that there are no leaks in the system. ■ Seal any leaks found. 7 - Whirlpool WED94HEAC | Ventilation Specification - Page 8
W10200920D © 2011. Whirlpool Corporation. All rights reserved. ® Registered Trademark/TM Trademark of Whirlpool, U.S.A. 3/11 Printed in U.S.A.
DRYER VENTING SPECIFICATIONS
W10100920D
Table of Contents
DRYER SAFETY
....................................................................................................................................
1
INSTALLATION REQUIREMENTS
......................................................................................................
4
Venting Requirements
.......................................................................................................................
5
DRYER INSPECTION AND CLEANING
..............................................................................................
7
Frequency of Exhaust System Cleaning
...........................................................................................
7
Inspecting the Exhaust System
.........................................................................................................
7
DRYER SAFETY
■
If you are installing a gas dryer, it is recommended that the owner post, in a prominent location, instructions for the customer’s use in
the event the customer smells gas. This information should be obtained from your local gas supplier.
Post the following warning in a prominent location.