Whirlpool WGD87HEDW Dimension Guide
Whirlpool WGD87HEDW Manual
 |
View all Whirlpool WGD87HEDW manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WGD87HEDW manual content summary:
- Whirlpool WGD87HEDW | Dimension Guide - Page 1
Gas Dryer PRODUCT MODEL NUMBERS WGD72HED, WGD81HED, WGD8740D, WGD87HED, WGD95HED, WGD97HED Front view: Side view: 27" (686 mm) 383/4" Min. (984 mm) 39" Max. (990 mm) Bottom view: Back view: 61/4" (159 mm) Recommended Installation Spacing: 53/4"* (146 mm) Vent Water inlet (Steam Models - Whirlpool WGD87HEDW | Dimension Guide - Page 2
larger tubing should be used. Pipe-joint compounds resistant to the action of L.P. gas must be used. An individual manual shutoff valve must be installed within 6 ft (1.8 m) of the dryer in accordance with the National Fuel Gas Code ANSI Z223.1. ELECTRICAL REQUIREMENTS A 120-volt, 60 Hz, AC-only, 15
-
1 -
2
 |
 |
Gas Dryer
PRODUCT MODEL NUMBERS
Front view:
Side view:
Back view:
Recommended Installation Spacing:
W10676163A
04/2014
WGD72HED, WGD81HED, WGD8740D, WGD87HED, WGD95HED, WGD97HED
Bottom view:
27"
(686 mm)
38
3
/
4
" Min.
(984 mm)
39" Max.
(990 mm)
6
1
/
4
"
(159 mm)
29
7
/
8
"*
(759 mm)
3
1
/
2
"*
(89 mm)
5
3
/
4
"*
(146 mm)
6
1
/
8
"*
(156 mm)
14
3
/
8
"
(365 mm)
25
3
/
4
"
(654 mm)
3
/
4
"*
(18 mm)
NOTE:
Most installations require a minimum of 5" (127 mm)
clearance behind dryer for exhaust vent with elbow. See
“Venting Requirements.”
18" min.
(457 mm)
1"
(25 mm)
5"
(127 mm)
24 in.
2
min.
(155 cm
2
)
48 in.
2
min.
(310 cm
2
)
3"
(76 mm)
3"
(76 mm)
1"
(25 mm)
Installation spacing for recessed area or closet installation
All dimensions show recommended and minimum spacing allowed.
■
Additional spacing should be considered for ease of installation and servicing.
■
Additional clearances might be required for wall, door, floor moldings, dryer venting, and gas line.
■
Additional spacing should be considered on all sides of the dryer to reduce noise transfer.
■
For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are
required. Louvered doors with equivalent ventilation openings are acceptable.
■
Companion appliance spacing should also be considered.
Gas
Water inlet
(Steam Models Only)
Vent