Whirlpool WGD88HEAW Ventilation Specification
Whirlpool WGD88HEAW Manual
View all Whirlpool WGD88HEAW manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WGD88HEAW manual content summary:
- Whirlpool WGD88HEAW | Ventilation Specification - Page 1
AND CLEANING 7 Frequency of Exhaust System Cleaning 7 Inspecting the Exhaust System ...7 DRYER SAFETY ■ If you are installing a gas dryer, it is recommended that the owner post, in a prominent location, instructions for the customer's use in the event the customer smells gas. This information - Whirlpool WGD88HEAW | Ventilation Specification - Page 2
2 - Whirlpool WGD88HEAW | Ventilation Specification - Page 3
3 - Whirlpool WGD88HEAW | Ventilation Specification - Page 4
combustible surfaces cannot be met. See the Installation Instructions for the specific dryer model being used or considered for spacing requirements. Moisture A normal towel load contains some residual water when it is removed from the washer. The dryer must remove this water and discharge it from - Whirlpool WGD88HEAW | Ventilation Specification - Page 5
In cases in which the Installation Instructions do not address the vent length dryer models. Codes Agency Approvals All Whirlpool electric dryer models, including "long vent dryers," Turbo Vent™ dryers and combo washer/dryer and servicing. ■ Additional clearances might be required for wall, door, and - Whirlpool WGD88HEAW | Ventilation Specification - Page 6
and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. ■ Companion appliance spacing should also be considered. Recommended room venting and installation spacing for recessed or closet installation, with stacked washer and dryer 48 in.2 * (310 cm2 - Whirlpool WGD88HEAW | Ventilation Specification - Page 7
the exhaust hood, check that the flapper or louvers move freely. 3. Reassemble the exhaust duct and hood, checking that the joints are secure. 4. Operate the dryer and verify that the exhaust air is not obstructed in the vent and that there are no leaks in the system. ■ Seal any leaks found. 7 - Whirlpool WGD88HEAW | Ventilation Specification - Page 8
W10200920D © 2011. Whirlpool Corporation. All rights reserved. ® Registered Trademark/TM Trademark of Whirlpool, U.S.A. 3/11 Printed in U.S.A.
DRYER VENTING SPECIFICATIONS
W10100920D
Table of Contents
DRYER SAFETY
....................................................................................................................................
1
INSTALLATION REQUIREMENTS
......................................................................................................
4
Venting Requirements
.......................................................................................................................
5
DRYER INSPECTION AND CLEANING
..............................................................................................
7
Frequency of Exhaust System Cleaning
...........................................................................................
7
Inspecting the Exhaust System
.........................................................................................................
7
DRYER SAFETY
■
If you are installing a gas dryer, it is recommended that the owner post, in a prominent location, instructions for the customer’s use in
the event the customer smells gas. This information should be obtained from your local gas supplier.
Post the following warning in a prominent location.