Whirlpool WGD92HEF Dimension Guide

Whirlpool WGD92HEF Manual

Get Whirlpool WGD92HEF PDF manuals and user guides View all Whirlpool WGD92HEF manuals
Add to My Manuals
Save this manual to your list of manuals

Whirlpool WGD92HEF manual content summary:

  • Whirlpool WGD92HEF | Dimension Guide - Page 1
    383/4" Min. (984 mm) 39" Max. (990 mm) GAS DRYER PRODUCT MODEL NUMBERS WGD7505F, WGD7540F, WGD7590F, WGD75HEF, WGD7740F, WGD77HEF, WGD90HEF, WGD92HEF of installation and servicing. ■■Additional clearances might be required for wall, door, floor moldings, dryer venting, and gas line. ■■Additional
  • Whirlpool WGD92HEF | Dimension Guide - Page 2
    larger tubing should be used. Pipe-joint compounds resistant to the action of L.P. gas must be used. An individual manual shutoff valve must be installed within 6 ft (1.8 m) of the dryer in accordance with the National Fuel Gas Code ANSI Z223.1. ELECTRICAL REQUIREMENTS A 120-volt, 60 Hz, AC-only, 15
  • 1
  • 2
GAS DRYER
PRODUCT MODEL NUMBERS
W10775221A
05/2016
WGD7505F, WGD7540F, WGD7590F, WGD75HEF, WGD7740F, WGD77HEF,
WGD90HEF, WGD92HEF, WGD85HEF
Back view
Side view
Front view
Spacing for recessed area or closet installation
All dimensions show recommended and minimum spacing allowed.
■
Additional spacing should be considered for ease of
installation and servicing.
■
Additional clearances might be required for wall, door, floor moldings, dryer venting, and gas line.
■
Additional spacing should be considered on all sides
of the dryer to reduce noise transfer.
■
For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings
are acceptable.
■
Companion appliance spacing should also be considered.
Recommended installation clearances
27"
(686 mm)
38
3
/
4
" Min.
(984 mm)
39" Max.
(990 mm)
6
1
/
4
"
(159 mm)
29
7
/
8
"*
(759 mm)
3
1
/
2
"*
(89 mm)
5
3
/
4
"*
(146 mm)
6
1
/
8
"*
(156 mm)
14
3
/
8
"
(365 mm)
25
3
/
4
"
(654 mm)
3
/
4
"*
(18 mm)
NOTE:
Most installations require a minimum of 5" (127 mm)
clearance behind dryer for exhaust vent with elbow. See
“Venting Requirements.”
* Approx. measurement
Gas
* Approx. measurement
Water inlet
(Steam Models Only)
Vent
18" min.
(457 mm)
1"*
(25 mm)
0" - 5"*
(0" - 127 mm)
24 in.
2
min.
(155 cm
2
)
48 in.
2
min.
(310 cm
2
)
3"
(76 mm)
3"
(76 mm)
1"
(25 mm)