Whirlpool WGE745C0FE Installation Instructions
Whirlpool WGE745C0FE Manual
 |
View all Whirlpool WGE745C0FE manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WGE745C0FE manual content summary:
- Whirlpool WGE745C0FE | Installation Instructions - Page 1
others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This chance of injury, and tell you what can happen if the instructions are not followed. IMPORTANT: Save for local electrical inspector's use. - Whirlpool WGE745C0FE | Installation Instructions - Page 2
range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. Range to comply with installation clearances specified on the model/serial/rating plate. The model/serial/rating plate is located behind the control - Whirlpool WGE745C0FE | Installation Instructions - Page 3
range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop width * Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs. ** Model/serial/rating plates may be rotated up from behind the control panel for viewing from the - Whirlpool WGE745C0FE | Installation Instructions - Page 4
be using and follow the instructions provided for it here. If load is less than the total connected load listed on the model/serial/ rating plate. ** If connecting to a 50-amp circuit in the line so that the range can be moved if servicing is ever necessary. ■■ A UL Listed conduit connector must - Whirlpool WGE745C0FE | Installation Instructions - Page 5
is less than the total connected load listed on the model/serial/rating plate. ** If connecting to a 50-amp not use an extension cord. INSTALLATION INSTRUCTIONS Unpack Range WARNING Excessive Weight Hazard the range on its back or with the range supported on 2 legs after the range has been placed - Whirlpool WGE745C0FE | Installation Instructions - Page 6
bracket. Re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. 1. Remove the anti-tip bracket that is taped inside the upper oven with the - Whirlpool WGE745C0FE | Installation Instructions - Page 7
new 40 amp power supply cord. Plug into a grounded outlet. Failure to follow these instructions can result in death, fire, or electrical shock. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper or 6 gauge aluminum wire. Electrically ground range. Failure to follow these - Whirlpool WGE745C0FE | Installation Instructions - Page 8
Assemble a UL Listed conduit connector in the opening. 5. Replace back panel and screws on rear of range. 6. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) Electrical Connection Options If your home has - Whirlpool WGE745C0FE | Installation Instructions - Page 9
4-Wire Connection: Power Supply Cord Use this method for: ■■ New branch-circuit installations (1996 NEC) ■■ Mobile homes ■■ Recreational vehicles ■■ In an area where local codes prohibit grounding through the neutral 1. Part of metal ground strap must be cut out and removed. A B C A. Metal ground - Whirlpool WGE745C0FE | Installation Instructions - Page 10
2. Use 3/8" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10-32 hex nuts. A E D B C A. 10-32 hex nut B. Line 1 (black) C. Ground-link screw D. Neutral (white) wire E. Line 2 (red) 3. Connect line 1 (black) and line 2 (red) wires to the outer - Whirlpool WGE745C0FE | Installation Instructions - Page 11
4. Attach terminal lugs to line 1 (black), neutral (white), and line 2 (red) wires. Loosen (do not remove) the setscrew on the front of the terminal lug and insert exposed wire end through bottom of terminal lugs. Securely tighten setscrew to XX lbs-in. torque. See "Bare Wire Torque Specifications" - Whirlpool WGE745C0FE | Installation Instructions - Page 12
range without anti-tip bracket installed and engaged. Please reference the "Assistance or Service" section of the Use and Care Guide, or the cover or the "Warranty" section of the User Instructions, to contact service. Level Range 1. Place a rack in oven. 2. Place level on rack and check levelness - Whirlpool WGE745C0FE | Installation Instructions - Page 13
instruction on range operation. If range does not operate, check the following: ■■ Household fuse is intact and tight, or circuit breaker has not tripped. ■■ Range is plugged into a grounded outlet. ■■ Electrical supply is connected. ■■ See the "Troubleshooting" section in the Use and Care Guide - Whirlpool WGE745C0FE | Installation Instructions - Page 14
Fixer la bride antibasculement au plancher ou au mur, conformément aux instructions d'installation. Faire glisser de nouveau la cuisinière de façon à antibasculement n'est pas installée et engagée. Le non-respect de ces instructions peut causer un décès ou des brûlures graves aux enfants et aux - Whirlpool WGE745C0FE | Installation Instructions - Page 15
composants nécessaires avant d'entreprendre l'installation. Lire et observer les instructions fournies avec chacun des outils de la liste ci-dessous. avec une cuisinière. Le cordon doit comporter les caractéristiques suivantes: service 250 volts minimum, 40 A ou 50 A, compatible avec une ouverture - Whirlpool WGE745C0FE | Installation Instructions - Page 16
(91,4 cm) de hauteur. IMPORTANT : En cas d'installation d'une hotte ou d'un ensemble hotte/micro-ondes au-dessus de la cuisinière, suivre les instructions fournies avec la hotte ou l'ensemble hotte/ microondes concernant les dimensions de dégagement à respecter au-dessus de la surface de la table de - Whirlpool WGE745C0FE | Installation Instructions - Page 17
portée de la position de service finale de la cuisinière. ■■ Ne pas utiliser de câble de rallonge. INSTRUCTIONS D'INSTALLATION Déballage de la cuisini plancher dans le sens de la longueur derrière la cuisinière en guise de support lorsque la cuisinière est placée sur sa partie postérieure. 4. À - Whirlpool WGE745C0FE | Installation Instructions - Page 18
Fixer la bride antibasculement au plancher ou au mur, conformément aux instructions d'installation. Faire glisser de nouveau la cuisinière de façon bride antibasculement n'est pas installée et engagée. Le non-respect de ces instructions peut causer un décès ou des brûlures graves aux enfants et aux - Whirlpool WGE745C0FE | Installation Instructions - Page 19
re et la paroi de montage. Pour assistance ou dépannage, consulter la section "Assistance ou Service" du guide d'utilisation et d'entretien, la couverture ou la section "Garantie" des instructions d'utilisation pour obtenir les coordonnées des personnes à contacter. 6. Répéter les étapes 1 et 2 pour - Whirlpool WGE745C0FE | Installation Instructions - Page 20
déformés. 8. Mettre l'appareil sous tension. Mettre en marche les éléments de surface et le four. Pour des instructions spécifiques concernant l'utilisation de la cuisinière, consulter le Guide d'utilisation et d'entretien. Si la cuisinière ne fonctionne pas, contrôler ce qui suit : ■■ Les fusibles
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
INSTALLATION INSTRUCTIONS FREESTANDING
ELECTRIC RANGE WITH DOUBLE OVENS
INSTRUCTIONS D'INSTALLATION POUR
CUISINIÈRE ÉLECTRIQUE AUTOPORTANTE AVEC
FOURS DOUBLES
RANGE SAFETY
.............................................................................
1
INSTALLATION REQUIREMENTS
.................................................
2
Tools and Parts
.............................................................................
2
Location Requirements
................................................................
2
Electrical Requirements - U.S.A. Only
.........................................
4
Electrical Requirements - Canada Only
.......................................
5
INSTALLATION INSTRUCTIONS
...................................................
5
Unpack Range
..............................................................................
5
Adjust Leveling Legs
....................................................................
5
Install Anti-Tip Bracket
.................................................................
6
Electrical Connection - U.S.A. Only
.............................................
7
Verify Anti-Tip Bracket Is Installed and Engaged
......................
12
Level Range
................................................................................
12
Complete Installation
.................................................................
13
Moving the Range
......................................................................
13
SÉCURITÉ DE LA CUISINIÈRE
...................................................
14
EXIGENCES D’INSTALLATION
...................................................
15
Outils et pièces
...........................................................................
15
Exigences d'emplacement
.........................................................
15
Spécifications électriques
..........................................................
17
INSTRUCTIONS D'INSTALLATION
.............................................
17
Déballage de la cuisinière
..........................................................
17
Réglage des pieds de nivellement
.............................................
17
Installation de la bride antibasculement
....................................
18
Vérifier que la bride antibasculement est bien
installée et engagée
...................................................................
18
Réglage de l'aplomb de la cuisinière
.........................................
19
Achever l’installation
..................................................................
20
Déplacement de la cuisinière
.....................................................
20
Table of Contents/Table des matières
W10575959B
IMPORTANT:
Save for local electrical inspector's use.
IMPORTANT :
À conserver pour consultation par l'inspecteur local des installations électriques.
RANGE SAFETY
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING