Xerox P8EX Bulletin - Powering Off and Powering On the CS Platform™
Xerox P8EX - DocuPrint B/W Laser Printer Manual
 |
UPC - 095205085853
View all Xerox P8EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Xerox P8EX manual content summary:
- Xerox P8EX | Bulletin - Powering Off and Powering On the CS Platform™ - Page 1
Powering Off and Powering On the CS Platform™ Procedure Stand-by Power Switch Status LED On / Off Switch Figure 1 Note: Before the IOT is powered off, make sure the IOT is not in the Diagnostic Mode. 1. Power "Off" the IOT 2. Switch "Off" the CS Platform™ using the On / Off Switch. (Figure 1) 3.
-
1
 |
 |
Powering Off and Powering On the CS Platform
™
Procedure
Stand-by Power Switch
Status LED
On / Off Switch
Figure 1
Note:
Before the IOT is powered off, make sure the IOT is
not
in the Diagnostic Mode.
1.
Power “
Off
” the IOT
2.
Switch “
Off
” the CS Platform
™
using the On / Off Switch. (Figure 1)
3.
Switch “
Off
” the Stand-by Power Switch.
4.
Switch “
On
” the Stand-by Power Switch
5.
Switch “
On
” the CS Platform
™
using the On / Off Switch. The CS Platform will beep and
the Status LED should start to blink. This will take approximately 60 seconds.
6.
Power “On” the IOT. Wait for the IOT to indicate that it is “Ready to Print”, before
resuming any CS Platform
™
activity.