Xerox WNA-100 How To Set Up and Configure the WNA-100 Wireless Network Adapter
Xerox WNA-100 - Bridge Manual
UPC - 095205230567
View all Xerox WNA-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Xerox WNA-100 manual content summary:
- Xerox WNA-100 | How To Set Up and Configure the WNA-100 Wireless Network Adapter - Page 1
How To Set up and Configure the WNA-100 Wireless Network Adapter Section 1: Set up and Connect the Adapter to a Computer, Then Configure the Computer to Communicate With the Adapter Before the adapter can be connected to a printer, it must be connected to a computer so that it can be configured to - Xerox WNA-100 | How To Set Up and Configure the WNA-100 Wireless Network Adapter - Page 2
or the manufacturer of the wireless router to obtain this information or refer to the wireless router's user guide. Without the network configuration for the wireless router, the WNA-100 cannot be configured correctly for a wireless Ethernet connection. • (Frequency) Band (for example: 802 - Xerox WNA-100 | How To Set Up and Configure the WNA-100 Wireless Network Adapter - Page 3
adapter's web interface, click on the [Help] button at the top, right of the web browser window. Section 3: Configure the TCP/IP Settings for the Wireless Router Management Note: This solution requires knowledge of the TCP/IP addressing scheme for wireless network that the WNA100 is being installed - Xerox WNA-100 | How To Set Up and Configure the WNA-100 Wireless Network Adapter - Page 4
.0.100 4. If necessary, configure any other settings displayed on the TCP/IP settings window. Note: For additional information about the various settings, click on the [Help] button at the top, right of the web browser window. Section 4: Configure the Wireless Adapter Administrative Utility Settings - Xerox WNA-100 | How To Set Up and Configure the WNA-100 Wireless Network Adapter - Page 5
of the window. Section 5: Reset the Adapter to Save All Settings, Then Connect the Adapter to the Printer 1. Click on the [Restart] button in the Reset section on the Administrative Utilities window, and then click on [Confirm] to reset the adapter so that all configuration settings will be saved
How To Set up and Configure the WNA-100 Wireless Network Adapter
Section 1:
Set up and Connect the Adapter to a Computer, Then Configure the Computer to
Communicate With the Adapter
Before the adapter can be connected to a printer, it must be connected to a computer so that it can be configured
to function on a wireless network. The adapter must be configured from the adapter's web interface using an
Internet browser. After the adapter has been connected to the computer, the computer's TCP/IP settings must be
configured to communicate with the adapter.
To set up the adapter:
1.
Connect the antenna to the adapter.
2.
Connect the power supply cord to the adapter, and then plug the power unit into the wall outlet.
Note:
Only use the power supply provided with the adapter.
3.
Connect one end of the supplied Ethernet crossover cable to the Ethernet port on the adapter.
4.
Connect the other end of the crossover cable to the Ethernet port on the computer that will be used to
configure the adapter using an Internet browser.
Note:
The adapter is not intended for use on a switch or hub. The adapter must be connected directly to