Yamaha AX-397 Owner's Manual

Yamaha AX-397 Manual

Get Yamaha AX-397 PDF manuals and user guides View all Yamaha AX-397 manuals
Add to My Manuals
Save this manual to your list of manuals

Yamaha AX-397 manual content summary:

  • Yamaha AX-397 | Owner's Manual - Page 1
    U AX-497/AX-397 Stereo Amplifier OWNER'S MANUAL
  • Yamaha AX-397 | Owner's Manual - Page 2
    INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE Listening For A Lifetime YAMAHA and the Electronic Industries
  • Yamaha AX-397 | Owner's Manual - Page 3
    instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA. 3 NOTE: This product has been tested instructions found in the users manual ON", please try to eliminate the problem by using one of the following , please contact Yamaha Electronics Corp.,
  • Yamaha AX-397 | Owner's Manual - Page 4
    please read this manual carefully. Keep it cause electrical shock to the user and/or damage to this qualified YAMAHA service personnel when any service is read the "TROUBLESHOOTING" section on de la fiche dans la borne correspondante de la prise et pousser jusqu'au fond. Cet appareil numérique de
  • Yamaha AX-397 | Owner's Manual - Page 5
    2 SUPPLIED ACCESSORIES 2 CONTROLS AND FUNCTIONS 3 Front panel 3 Remote control 5 Installing batteries in the remote control 6 Using the remote control 6 Rear panel 7 tonal quality 13 Recording a source to a tape or an MD 14 ADDITIONAL INFORMATION TROUBLESHOOTING 16 SPECIFICATIONS 18 1
  • Yamaha AX-397 | Owner's Manual - Page 6
    AMP switch used to reproduce the purest CD and DVD sound ◆ Remote control capability [ AX-497 ] ◆ Minimum RMS output power 85 W + 85 W (8 Ω), 0.019% THD, 20 Hz to 20 kHz ◆ REC OUT selector independent of input source selection ◆ PURE DIRECT switch used to reproduce the purest source sound [ AX-397
  • Yamaha AX-397 | Owner's Manual - Page 7
    AX-497 12 34 CONTROLS AND FUNCTIONS CONTROLS AND FUNCTIONS 5 68 STANDBY POWER ON OFF STANDBY /ON INPUT AUX MD TAPE CD/DVD TUNER PHONO PURE DIRECT CD/DVD DIRECT AMP 8 40 4 60 ∞ -dB 2 0 ■ AX-397 12 34 9 0 A B C DE 5 F 78 STANDBY POWER ON OFF STANDBY /ON remote control. 3
  • Yamaha AX-397 | Owner's Manual - Page 8
    Remote control sensor Receives signals from the remote control. 5 INPUT selector and indicators Selects the input source you want to listen to. The input source indicators light up when the corresponding input sources are selected. 6 PURE DIRECT and indicator (AX (AX-397 /DVD DIRECT AMP and indicator
  • Yamaha AX-397 | Owner's Manual - Page 9
    other components The functions of the buttons to control other YAMAHA components are the same as those of the corresponding buttons on those components. Refer to those components' instruction manuals for details. 6 Tuner buttons Control various functions of the tuner. PRESET +/- Selects a preset
  • Yamaha AX-397 | Owner's Manual - Page 10
    control The remote control transmits a directional infrared beam. Be sure to aim the remote control directly at the remote control sensor on the front panel of this unit during operation. 2 STANDBY POWER ON OFF STANDBY /ON INPUT AUX MD TAPE CD/DVD TUNER PHONO PURE DIRECT CD/DVD DIRECT AMP
  • Yamaha AX-397 | Owner's Manual - Page 11
    INTRODUCTION Rear panel 1 2 CONTROLS AND FUNCTIONS 3 4 PHONO GND CD/DVD TUNER IN (PLAY) TAPE OUT (REC) IN (PLAY) MD OUT (REC) AUX SPEAKERS + - - + A B IMPEDANCE SELECTOR A OR B: 4ΩMIN / SPEAKER A+B: 8ΩMIN /
  • Yamaha AX-397 | Owner's Manual - Page 12
    the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. Also, refer to the owner's manual for each of your components. • Use RCA type pin plug cables for audio/video units except speakers. • Connect your turntable to the GND terminal to
  • Yamaha AX-397 | Owner's Manual - Page 13
    PREPARATION 1 Remove approximately 10 mm (3/8 in) of insulation from the end of each speaker cable and twist the exposed wires of the cable together to prevent short circuits. 10 mm (3/8 in) CONNECTIONS ■ Connecting the banana plug (With the exception of Asia, Korea, U.K. and Europe models) First,
  • Yamaha AX-397 | Owner's Manual - Page 14
    ■ AC OUTLET(S) (SWITCHED) U.K. and Australia models 1 outlet Korea model None Other remote control). The outlet(s) supply power to any connected component whenever the power of this unit is turned on. For information on the maximum power (total power consumption of components), see "SPECIFICATIONS
  • Yamaha AX-397 | Owner's Manual - Page 15
    As for AX-397 only, ON OFF STANDBY /ON INPUT AUX MD TAPE CD/DVD TUNER PHONO PURE DIRECT CD/DVD DIRECT AMP PHONES SPEAKERS A B ON OFF BASS 1 2 3 4 -5 1 2 3 4 5+ TREBLE (or press one of the input selector buttons on the remote control) to select the input source you want to listen to.
  • Yamaha AX-397 | Owner's Manual - Page 16
    or LOUDNESS 1 FLAT -30dB 2 10 3 9 4 8 567 CD/DVD DIRECT AMP Note As for AX-497 only, you can also adjust the tonal quality by using PURE DIRECT on the front panel. 8 Press STANDBY/ON on the front panel again (or STANDBY on the remote control) to finish using this unit and set it to
  • Yamaha AX-397 | Owner's Manual - Page 17
    AX-397 only) and then sent to the power amplifier, thus eliminating any alterations to the CD or DVD signals and creating the purest possible sound. Lights up CD/DVD DIRECT AMP PLAYING AND RECORDING ■ Adjusting the LOUDNESS control or press VOLUME +/- on the remote control) to set the sound output
  • Yamaha AX-397 | Owner's Manual - Page 18
    VOLUME, BASS, TREBLE, BALANCE and LOUDNESS controls and the CD/DVD DIRECT AMP switch (and the PURE DIRECT switch for AX-497 only) have no effect on the the front panel (or press one of the input selector buttons on the remote control) to select the input source you want to listen to. INPUT or
  • Yamaha AX-397 | Owner's Manual - Page 19
    ■ AX-397 STANDBY POWER ON OFF STANDBY /ON INPUT AUX MD TAPE CD/DVD TUNER PHONO PHONES SPEAKERS A B ON OFF BASS 1 2 3 4 -5 1 2 3 4 5+ TREBLE 1 2 3 4 -5 1 2 3 4 5+ BALANCE 1 2 3 4 L5 1 2 3 4 5R LOUDNESS 1 FLAT -30dB 2 10 3 9 4 8 567 TAPE MONITOR CD/DVD DIRECT AMP
  • Yamaha AX-397 | Owner's Manual - Page 20
    instructions below do not help, set this unit to the standby mode, disconnect the power cord, and contact the nearest authorized YAMAHA dealer or service center. ■ General Problem selector buttons on the remote control). The TAPE MONITOR MC cartridge. the MC head amplifier. - record. The volume
  • Yamaha AX-397 | Owner's Manual - Page 21
    TROUBLESHOOTING The AMP switch (or the PURE TREBLE, BALANCE the PURE DIRECT switch for AX-497 DIRECT switch for AX-497 only) must be turned off and LOUDNESS controls does not only) is turned on. to use those controls. 13 affect the tonal quality. ■ Remote control Problem The remote control
  • Yamaha AX-397 | Owner's Manual - Page 22
    88 dB or more CD (input shorted) CD/DVD DIRECT AMP ON 110 dB or more • Residual Noise (IHF-A Network) [AX-497] CD/DVD DIRECT AMP ON 35 µV PURE DIRECT ON 90 µV [AX-397] CD/DVD DIRECT AMP ON 35 µV CD/DVD DIRECT AMP OFF 100 µV CONTROL SECTION • Input Sensitivity/Input Impedance PHONO 2.5 mV/47
  • Yamaha AX-397 | Owner's Manual - Page 23
    -BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
AX-497/AX-397
Stereo Amplifier
OWNER’S MANUAL
U