Yamaha DSP-A2 Owner's Manual - Page 16
Connections, Audio/video source equipment, Basic connections of audio units
View all Yamaha DSP-A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
PREPARATION Connections Caution: Plug in this unit and other components after all connections are completed. All connections must be correct, that is to say L (left) to L, R (right) to R, "+" to "+" and "-" to "-". Also refer to the owner's manual for each of your components. Audio/video source equipment q Use RCA type pin plug cables for audio/video units with the exception described later. q The output (or input) terminals of YAMAHA audio/video units numbered as 1, 2, 3, 4, etc. on the rear panel must be connected to the same-numbered terminals of this unit. Ⅵ Basic connections of audio units Turntable GND OUTPUT (*1) CD player OUTPUT MD recorder, Tape deck, etc. LINE OUT LINE IN Tuner OUTPUT (Europe model) GND DIGITAL RF SIGNAL DVD/LD CD COAXIAL OPTICAL CD IN (PLAY) TAPE/MD OUT (REC) DVD/LD TV/DBS AUDIO SIGNAL PHONO AUDIO SIGNAL VIDEO DVD/LD VIDEO SIGNAL S VIDEO DVD/LD 1 CD 3 IN ( PLAY ) TAPE/MD 4 OUT ( REC ) MAIN SURROUND SUB WOOFER CENTER EXTERNAL DECODER INPUT TV/DBS IN VCR 1 OUT IN VCR 2 OUT 2 TUNER TV/DBS IN VCR 1 OUT IN VCR 2 OUT S VIDEO MONITOR OUT VIDEO DIGITAL SIGNAL (*1): GND terminal (For turntable use) Connecting the ground wire of the turntable to the GND terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected. 14 : Indicates the direction of signals.