Yamaha EMX5000-20 Owner's Manual - Page 24
Basic operation, Connecting microphones and instruments, Using the digital effect
View all Yamaha EMX5000-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
22 Basic operation Basic operation Connecting microphones and instruments 1 Before connecting mics or instruments, make sure that the power of all equipment (where applicable) is turned off. Also make sure that each channel fader and the faders in the master section are turned down. Check to see if the Power amp select switch on the control panel is set to ST L-R. 2 Connect cables to your mics and instrument, and insert the other end of the cables firmly into the appropriate INPUT A/B jacks (EMX5000-20: channels 1-16, EMX5000-12: channels 1-8) or the 17L/ 18R, 19L/20R (EMX5000-20), 9L/10R, 11L/12R (EMX5000-12) jacks. Note: You cannot use channel 1-16 (EMX5000-20), 1-8 (EMX5000-12) INPUT A and B jacks at the same time. 3 Turn on the power to the peripheral devices, then turn on the power to the EMX5000-20/EMX5000-12. Note: When turning the power off, reverse this sequence. 4 While speaking into the mic (or while playing the instrument), adjust the channel GAIN control so that the channel PEAK indicator lights occasionally at the maximum volume. 5 Raise the ST OUT fader in the master section to the "10" position, and while speaking into the mic (or while playing the instrument), adjust the channel fader so that the 0 LED of the peak level indicator lights occasionally. Use the LEVEL control to adjust the maximum level of the speakers. 6 If you wish to adjust the tone of each channel, rotate the equalizer controls as desired. 7 Use the graphic equalizer and the ST fader in the master section to adjust the overall volume and tone. Note: The volume level is affected by the settings of the channel equalizers and the graphic equalizer. When you set the equalizers, check the peak level indicator and adjust the ST fader if necessary. Using the digital effect The EMX5000-20/EMX5000-12 has a built-in digital effect, allowing reverberation or ambiance to be added to vocals or instrumental sounds. 1 Connect a mic or instrument to the desired channels, and adjust the volume and tone. 2 Press the ON switch of the digital effect section. 3 Use the PROGRAM selector to select the type of effect you wish to apply. 4 Raise the EFF 1 (or EFF 2) control of the channels to which you wish to apply the digital effect. 5 Use the EFFECT 1 (or EFFECT 2) RTN fader of the digital effect section to adjust the level of the effect sound. Note: You can send the effect sound to the AUX 1/2 bus by raising the AUX 1/2 control in the digital effect section. If the effect sound is distorted even though the ST control and the AUX 1/2 controls in the digital effect section are turned all the way down, lower the EFF 1 (or EFF 2) controls of the digital effect section. 6 Adjust the PARAMETER control of the digital effect section to the desired level. Note: The setting of the AUX 1/2 fader in the master section does not affect the internal effect. EMX5000-20/EMX5000-12-Owner's Manual