Yamaha HTR-5280 Owner's Manual - Page 27

INTRODUCTION PREPARATION BASIC OPERAIONT The state of the test tone output is also shown on the monitor by an image of the audio listening room. This is convenient for adjusting each speaker level. TEST DOLBY SUR. LEFT y • If "1A CENTER SP" on the SET MENU is set to NONE, the center channel sound is automatically output from the left and right main speakers. Note • If the test tone cannot be heard, turn down the volume, set the unit in the standby mode and check the speaker connections. 4 Press LEVEL repeatedly to select the speaker to be adjusted. y • Once you press LEVEL, you can also select the speaker to be adjusted by pressing d. (Pressing u changes the selection in the reverse order.) ADJUSTING THE SPEAKER OUCTOPNUNTELCETVIOENLS y • The tonal quality of the center speaker can be adjusted by using "5 CENTER GEQ" on the SET MENU (see page 40). • You can increase the output levels of the effect speakers (center, left rear and right rear) to +10 dB. If the output level of these speakers is lower than that of the main speakers even after you have increased the output level of these speakers up to +10 dB, set "1E MAIN LEVEL" on the SET MENU to -10 dB (see page 39). This setting decreases the main speaker output level to about one-third of the normal level. After you have set "1E MAIN LEVEL" on the SET MENU to -10 dB, adjust the levels for the center and rear speakers again. 5 Press j / i repeatedly to adjust the output level of the effect speakers so that the output level coming from each speaker is the same. While adjusting, the test tone is heard from the selected speaker. 6 When the adjustment is complete, press TEST. The test tone stops and the current DSP program appears on the front panel display and on the video monitor. ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 23