Yamaha HTR-5280 Owner's Manual - Page 55
Setting the Manufacturer Code, To use a second and third VCR
UPC - 072874307073
View all Yamaha HTR-5280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
INTRODUCTION PREPARATION BASIC OPERAIONT Setting the Manufacturer Code You can set up the code for the manufacturer of your component in each position of the selector dial. 1 Turn on your component to be used. 2 Set the selector dial to the desired position for the component (TAPE/MD, CD, DVD/LD, etc.). 3 Press j / i at the same time for about 4 seconds. The indicator flashes twice. REMOTE CONTROL FEATURES I To use a second (and third) VCR You can control a second (and third) VCR in the CBL/ SAT and DVD MENU positions if a cable TV/satellite tuner or DVD player is not being used. Note • If you want to control a second (and third) VCR in the DVD MENU position, you must set up the code for an LD player in the DVD/LD position. 1 Turn on the VCR to be used. 2 Set the selector dial to the CBL/SAT or DVD MENU position. 4 Use the numeric buttons to enter the four-digit manufacturer code for the component to be used. Make sure that the indicator flashes twice. If the indicator does not flash or flashes rapidly several times, repeat step 3 and reenter the code. 5 Press AV POWER (or any other button) to check if you have set up the code correctly. If your component cannot be controlled with the remote control, try setting another code for the same manufacturer. Notes • You can set up only one code for one position. • In the DVD/LD and DVD MENU positions: Be sure to set the selector dial to the DVD/LD position before entering the code for the DVD/LD player. The code set up in the DVD/LD position is also simultaneously set up in the DVD MENU position. You cannot set up the code for a DVD player when the selector dial is set to the DVD MENU position. • If your component does not respond to any of the codes listed for the manufacturer, you can program functions from the other remote control's functions (see page 52 for details). • If you have already programmed a remote control function to a button, the function by programming (see page 52) takes priority over the set up manufacturer code's function. 3 Press j / i at the same time for about 4 seconds. The indicator flashes twice. 4 Use the numeric buttons to enter the four-digit code for the second (and third) VCR. Make sure that the indicator flashes twice. If the indicator does not flash or flashes rapidly several times, repeat step 3 and reenter the code. 5 Press AV POWER (or any other button) to check if you have set up the code correctly. If the VCR cannot be controlled with the remote control, try setting another code for the same manufacturer. ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 51