Yamaha HTR-5280 Owner's Manual - Page 65
Changing Parameter Settings, Resetting a Parameter to the, Factory-set Value
UPC - 072874307073
View all Yamaha HTR-5280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
INTRODUCTION PREPARATION BASIC OPERATION SOUND FIELD PROGRAM PARAMETER EDITING Changing Parameter Settings You can enjoy good quality sound with the factory-set parameters. Although you do not have to change the initial settings, you can change some of the parameters to better suit the input source or your listening room. Adjustments should be made with the remote control. y • We recommend that you edit the parameter while using a video monitor. It is easier to see the video monitor than it is to see the front panel display. 3 2 1 4 5 3 1 Set the selector dial to the DSP/TUN (or AMP/TUN) position. or 2 Turn on the video monitor and press ON SCREEN repeatedly to select the full display mode. 3 Select a DSP program you want to adjust. Program No. Program name (group) Cursor P04 ROCK CONCERT INIT.DLY LIVENESS REV.TIME REV.DELAY REV.LEVEL 15ms 5 1.6s 100ms 7% Parameters Example of the ROCK CONCERT 4 Press u/d to select the parameter. 5 Press j / i to change the parameter value. y • When you set the parameter to a value other than the factoryset value, an asterisk mark (*) appears by the parameter name on the video monitor 6 Repeat steps 3 to 5 above as necessary to change other program parameters. Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter value you edited will return to the factory setting. If so, edit the parameter value again. Resetting a Parameter to the Factory-set Value I To reset some of the parameters to the factory-set values Select the parameter you want to reset. Then press and hold j or i until the value temporarily stops at the factory-set value. The asterisk mark (*) by the parameter name disappears on the video monitor. I To reset all of the parameters to the factory-set values Use "9 PARAM. INI" on the SET MENU to reset all of the parameter values of all DSP programs within the selected group to the factory-set values (see page 41). This operation resets all of the parameter values of all DSP programs within that group to the factory-set values. Notes • The available parameters may be displayed on more than one OSD page for some of the programs. To scroll through pages, press u/d. • You cannot change parameter values when "15 MEMORY GUARD" on the SET MENU is set to ON. If you want to change the parameter values, set "15 MEMORY GUARD" to OFF (see page 43). ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 61