Yamaha HTR-5280 Owner's Manual - Page 74
Remote control
UPC - 072874307073
View all Yamaha HTR-5280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
TROUBLESHOOTING I Remote control Problem The remote control does not work nor function properly. The unit or other component cannot be controlled. The remote control does not "learn" new functions. Cause Remedy Wrong distance or angle. The remote control will function within a maximum range of 6 m (20 feet) and no more than 30 degrees off-axis from the front panel. Direct sunlight or lighting (from an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. The batteries are weak. The component to be controlled has not been selected. The remote control cannot control system components. Reposition the unit. Replace all batteries with new ones. Set the selector dial to the appropriate position, corresponding to the component to be controlled. The manufacturer code has not been set up properly. Enter the code again. Try setting another code for the same manufacturer. Depending on the manufacturer or the model, some components cannot be controlled with this unit's remote control even though the code has been set up properly. Program functions from the other remote control's function into this remote control. Refer to page 8 - 3 46 - 51 52 The batteries of this remote control and/or Replace the batteries. 3 the other remote control are too weak. The distance between the two remote Place the remote controls at the proper 52 controls is too much or too little. distance. The signal coding or modulation of the Learning is not possible. 52 other remote control is not compatible with this remote control. Memory capacity is full. Further learning is not possible without 52 deleting unnecessary functions. After this unit has been exposed to a strong external electric shock (such as lightning and strong static electricity) or if you mishandle the operation of this unit, it may not function properly. In these cases, set this unit in the standby mode, disconnect the power cord, plug it back in after 30 seconds, and start operating. 70