Yamaha HTR-5280 Owner's Manual - Page 75

INTRODUCTION PREPARATION BASIC OPERAIONT SPECIFICATIONS AUDIO SECTION • Minimum RMS Output Power for Main, Center, Rear 20 Hz to 20 kHz, 0.04% THD, 8 ohms 100 W 1 kHz, 0.04% THD, 8 ohms 105 W • Maximum Power (EIAJ) [China and general models] 1 kHz, 10% THD, 8 ohms 140 W • Dynamic Power (IHF) 8/6/4/2 ohms 125/160/195/230 W [U.S.A. model] 135/170/205/245 W • Damping Factor 20 Hz to 20 kHz, 8 ohms 80 or more • Frequency Response CD to Main L/R 10 Hz to 100 kHz, -3 dB • Total Harmonic Distortion 20 Hz to 20 kHz, 50 W, 8 ohms, Main L/R 0.04% • Signal to Noise Ratio (IHF-A Network) PHONO MM to REC OUT (5 mV, shorted) [U.S.A., Canada, China and general models 86 dB [Australia and Singapore models 81 dB CD (250 mV, shorted) to Main L/R, Effect Off 100 dB • Residual Noise (IHF-A Network) Main L/R 150 µV or less • Channel Separation (1 kHz/10 kHz) CD (5.1 kohms terminated) to Main L/R 60 dB/45 dB • Tone Control (Main L/R) BASS Boost/Cut 10 dB/50 Hz TREBLE Boost/Cut 10 dB/20 kHz BASS EXTENSION 6 dB/60 Hz • Phones Output 150 mV/100 ohms • Input Sensitivity CD, etc 150 mV/47 kohms PHONO 2.5 mV/47 kohms 6CH INPUT 150 mV/40 - 47 kohms • Output Level REC OUT 150 mV/0.9 kohms PRE OUT 2.6 V/1.2 kohms SUBWOOFER 4.0 V/1.2 kohms VIDEO SECTION • Video Signal Type NTSC or PAL • Composite Video Signal Level 1 Vp-p/75 ohms • S-Video Signal Level Y 1 Vp-p/75 ohms C 0.286 Vp-p/75 ohms • Component Video Signal Level Y 1 Vp-p/75 ohms PB/CB, PR/CR 0.7 Vp-p/75 ohms • Signal to Noise Ratio 50 dB • Frequency Response (MONITOR OUT) Composite, S-Video 5 Hz to 10 MHz, -3 dB Component DC to 30 MHz, -3 dB FM SECTION • Tuning Range [U.S.A. and Canada models 87.5 to 107.9 MHz [Others 87.50 to 108.00 MHz • 50 dB Quieting Sensitivity (IHF, 100% mod.) Mono/Stereo 2.0 µV (17.3 dBf) /25 µV (39.2 dBf) • Selectivity (400 kHz 70 dB • Signal to Noise Ratio (IHF) Mono/Stereo 76 dB/70 dB • Harmonic Distortion (1 kHz) Mono/Stereo 0.2%/0.3% • Stereo Separation (1 kHz 45 dB • Frequency Response 20 Hz to 15 kHz +0.5, -2 dB AM SECTION • Tuning Range 530/531 to 1710/1611 kHz • Usable Sensitivity 300 µV/m GENERAL • Power Supply [U.S.A. and Canada models AC 120 V/60 Hz [Australia model AC 240 V/50 Hz [Singapore model AC 230 V/50 Hz [China model AC 220 V/50 Hz [General model AC 110/120/220/240 V, 50/60 Hz • Power Consumption approx. 300 W/360 VA Standby Mode approx. 1.5 W • AC Outlets (Total 100 W/1A maximum 2 (SWITCHED) [Australia model 1 (SWITCHED) • Dimension (W x H x D 435 x 171 x 432 mm (17-1/8" x 6-3/4" x 17") • Weight 15 kg (33 lbs) • Accessories Remote Control Batteries AM loop antenna Indoor FM antenna Quick Reference Card *Specifications are subject to change without notice. ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 71