Yamaha HTR 5740 MCXSP10 Manual - Page 15
Speaker connections, Banana plug connections - setup
UPC - 027108918907
View all Yamaha HTR 5740 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
PREPARATION SPEAKER SETUP Speaker connections Be sure to connect the left channel (L), right channel (R), "+" (red) and "-" (black) properly. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. CAUTION • If you will use 6 ohm speakers, be sure to set this unit's speaker impedance setting to 6 ohms before using (see page 20). • Before connecting the speakers, make sure that the power of this unit is off. • Do not let the bare speaker wires touch each other or do not let them touch any metal part of this unit. This could damage this unit and/or speakers. • Use magnetically shielded speakers. If this type of speakers still creates the interference with the monitor, place the speakers away from the monitor. A speaker cord is actually a pair of insulated cables running side by side. One cable is colored or shaped differently, perhaps with a stripe, groove or ridges. Connect the striped (grooved, etc.) cable to the "+" (red) terminals on this unit and your speaker. Connect the plain cable to the "-" (black) terminals. 10 mm (3/8") 5 Tighten the knob to secure the wire. 3 4 5 Red: positive (+) Black: negative (-) ■ Banana plug connections (With the exception of U.K. and Europe models) First, tighten the knob and then insert the banana plug connector into the end of the corresponding terminal. Banana plug (With the exception of U.K. and Europe models) 1 2 1 Remove approximately 10 mm (3/8") of insulation from the end of each speaker cable. 2 Twist the exposed wires of the cable together to prevent short circuits. 3 Unscrew the knob. 4 Insert one bare wire into the hole in the side of each terminal. English 11