Yamaha HTR 6230 Owner's Manual - Page 31

INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION FM/AM tuning Overview You can use two tuning modes to tune into a desired FM/ AM station: ■ Frequency tuning mode You can search or specify the frequency of the desired FM/AM station automatically or manually (see "FM/AM tuning operations" on this page). ■ Preset tuning mode You can preset the desired FM/AM station in advance, and then recall the station by specifying the preset group and number (see "Selecting preset stations" on page 28). Note • Orient the connected AM loop antenna, or adjust the position of the end of the indoor FM antenna for the best reception. FM/AM tuning operations 1 Press NINPUT l / h repeatedly so that "TUNER" is displayed on the front panel display. 2 Press GBAND to select the reception band (FM or AM). 3 To search the station automatically, press ITUNING AUTO/MAN'L so that the AUTO indicator lights up on the front panel display. To search the station manually, press ITUNING AUTO/MAN'L again so that the AUTO indicator disappears from the front panel display. Lights up during automatic tuning AUTO A AM 1440 kHz No colon (:) If a colon (:) appears on the front panel display, automatic/manual tuning is not possible. Press DEDIT PRESET/TUNING to turn the colon (:) off. 4 To begin automatic tuning, press FPRESET/TUNING l / h once. To tune into the desired station manually, press FPRESET/TUNING l / h repeatedly. When this unit is tuned into a station, the TUNED indicator lights up and the frequency of the received station is shown on the front panel display. Lights up AUTO TUNED A AM 1530 kHz • To tune into a higher frequency, press FPRESET/TUNING h. • To tune into a lower frequency, press FPRESET/ TUNING l. Note • If the signal from the station you want to select is weak, tune into it manually. Preset FM/AM stations Use this feature to store up to 40 stations (A1 to E8: 8 preset station numbers in each of 5 preset station groups). Preset the desired stations to this unit by using the automatic or manual station preset. Automatic station preset You can use the automatic preset tuning feature to store up to 40 FM stations with strong signals in order. 1 Press NINPUT l / h repeatedly so that "TUNER" is displayed on the front panel display. 2 Press GBAND to select "FM" as the reception band. 3 Press and hold HMEMORY for more than 3 seconds. The preset station number as well as the MEMORY and AUTO indicators flashes. After approximately 5 seconds, automatic presetting status from the current frequency and proceeds toward the higher frequencies. Flashes AUTO MEMORY A1:FM 87.5 MHz Flashes When automatic preset tuning is completed, the front panel display shows the frequency of the last preset station. ADDITIONAL INFORMATION APPENDIX English 27 En