Yamaha HTR 6230 Owner's Manual - Page 37

INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION LFE signals output Choice Subwoofer Front speakers Other speakers BOTH* Output No output No output SWFR Output No output No output FRONT No output Output No output Low-frequency signals output Choice Subwoofer Front speakers Other speakers BOTH* *1 *2 *3 SWFR *4 *3 *3 FRONT No output *1 *3 Notes *1 Outputs the low-frequency signals of the front channels and other speakers to "SML" or "NONE." *2 Always output the low-frequency signals of the front channels. *3 Output the low-frequency signals if the sizes of speakers are set to "LARGE" (or "LRG"). *4 Output the low-frequency signals of the speakers set to "SML." ■ Crossover CROSSOVER Use this feature to select a crossover frequency of all the speakers set to "SML" (or "SMALL") or to "NONE" in "SPEAKER SET" (see pages 31 and 32). Choices: 40Hz, 60Hz, 80Hz*, 90Hz, 100Hz, 110Hz, 120Hz, 160Hz, 200Hz Note • All frequencies below the selected frequency will be sent to the subwoofer or to the speakers set to "LRG" (or "LARGE") in "SPEAKER SET" (see pages 31 and 32). ■ Subwoofer phase SWFR PHASE Use this feature to switch the phase of your subwoofer if bass sounds are lacking or unclear. Choice Function NRM* Does not reverse the phase of your subwoofer. REV Sets the phase of your subwoofer to reverse. Speaker level B)SP LEVEL Use this feature to manually adjust the output level of each speaker. Control range: -10 to 0* to +10 dB Control step: 1 dB SP LEVEL FL FR C SL SR SWFR Adjusted speaker Front left speaker Front right speaker Center speaker Surround left speaker Surround right speaker Subwoofer Set menu Notes • The available speaker channels differ depending on the setting of the speakers. • This does not affect recorded material. Speaker distance C)SP DISTANCE Use this feature to manually adjust the distance of each speaker and the delay applied to the respective channel. All sounds would be adjusted to arrive at the listening position at the same time regardless of distance from each speaker. ■ Unit UNIT Choice Condition meters When you adjust speaker distances in meters. feet* When you adjust speaker distances in feet. ■ Speaker distances Control range: 0.30 to 24.00 m (1.0 to 80.0 ft) Control step: 0.10 m (0.5 ft) Initial setting: FRONT L/FRONT R/SWFR: 3.00 m (10.0 ft) CENTER: 2.60 m (8.5 ft) SUR. L/SUR. R: 2.40 m (8.0 ft) SP DISTANCE FRONT L FRONT R CENTER SUR. L SUR. R SWFR Adjusted speaker Front left speaker Front right speaker Center speaker Surround left speaker Surround right speaker Subwoofer Note • The available speaker channels differ depending on the setting of the speakers. Center graphic equalizer D)CENTER GEQ Use this feature to adjust the built-in 5-frequency band (100Hz, 300Hz, 1kHz, 3kHz and 10kHz) graphic equalizer for the center channel so that the tonal quality of the center speaker matches that of the front speakers. Control range: -6.0 to 0* to +6.0 dB Control step: 0.5 dB y • Press lk / n to select a frequency band and ll / h to adjust the selected frequency band. • You can make adjustment while listening to the currently source or a test tone. Following is an example where "100Hz" is selected as the frequency band. 100Hz--||-- 0 ADDITIONAL INFORMATION APPENDIX English 33 En