Yamaha NS-1000MM Owner's Manual

Yamaha NS-1000MM Manual

Get Yamaha NS-1000MM PDF manuals and user guides View all Yamaha NS-1000MM manuals
Add to My Manuals
Save this manual to your list of manuals

Yamaha NS-1000MM manual content summary:

  • Yamaha NS-1000MM | Owner's Manual - Page 1
    Yamaha NS-1000MM speaker system. CAUTIONS Read this before using the speakers. ● To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. ● Install the speakers the speakers. Contact qualified YAMAHA service personnel when any service is
  • Yamaha NS-1000MM | Owner's Manual - Page 2
    To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall. 2 Remove the speaker for mounting the speakers on the wall or the ceiling (if you will not use the provided mounting brackets). Rear Bottom 64 mm 60 mm 60 mm 3 Fasten screws into a firm wall or wall support
  • Yamaha NS-1000MM | Owner's Manual - Page 3
    (L) How to Connect: 1 Loosen the terminal knob. 2 Insert the bare wire end properly into the terminal hole. [Remove the insulation from both ends of the speaker cable.] 10 mm 3 Tighten the knob and secure the cable. Test the firmness of the connection by pulling lightly on the cable at the terminal
  • Yamaha NS-1000MM | Owner's Manual - Page 4
    away from the TV set. SPECIFICATIONS Type ......... 3-way acoustic-suspension speaker system Magnetically shielded type Driver 12 cm (4-3/4") cone woofer 2.5 cm (1") dome mid-range 1.5 cm (9/16") dome tweeter Nominal Impedance 6 ohms Frequency Response 70 Hz - 24 kHz Nominal Input Power 60W
  • 1
  • 2
  • 3
  • 4
CAUTIONS
Read this before using the speakers.
●
To assure the finest performance, please read this
manual carefully.
Keep it in a safe place for future
reference.
●
Install the speakers in a cool, dry, clean place –
away from windows, heat sources, sources of
excessive vibration, dust, moisture and cold.
Avoid
sources of humming (transformers, motors).
To
prevent fire or electric shock, do not expose the
speakers to rain or water.
●
To prevent the enclosure from warping or
discoloring, do not place the speakers where they
will be exposed to direct sunlight or excessive
humidity.
●
Do not place the following objects on top of the
speakers:
•
Other components, as they might cause damage
and/or discoloration on the surface of the
speakers.
•
Burning objects (i.e. candles), as they might cause
fire, damage to the speakers and/or personal
injury.
•
Containers with liquid in them. If the liquid spills, it
might cause electric shock to the user and/or
damage to the speakers.
●
Do not place the speakers where they are liable to
be knocked over or struck by falling objects.
Stable
placement will also ensure better sound
performance.
●
Placing the speakers on the same shelf or rack as
the turntable can result in feedback.
●
Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident caused
by improper placement or installation of speakers.
●
Any time you note distortion, reduce the volume
control on your amplifier to a lower setting.
Never
allow your amplifier to be driven into “clipping”.
Otherwise the speakers may be damaged.
NS-1000MM
Natural Sound 3-way acoustic-suspension speaker system
Thank you for selecting the Yamaha NS-1000MM speaker system.
●
When using an amplifier with a rated output power
higher than the nominal input power of the speakers,
care should be taken never to exceed the speakers’
maximum input.
●
Do not attempt to clean the speakers with chemical
solvents as this might damage the finish.
Use a
clean, dry cloth.
●
Do not attempt to modify or fix the speakers.
Contact qualified YAMAHA service personnel when
any service is needed.
The cabinet
should never be
opened for any reasons.
G
REMOVING THE FRONT COVER
The front cover is fastened to the enclosure at four
points and can be removed if desired. To remove the
cover, hold on to both sides and slowly pull straight
away from the speaker. To reattach, line up the four
holes on the inner surface of the cover with the four
corresponding pegs on the speaker and push gently.
Note
When the cover is removed, be sure not to touch
the speaker units with your hands or to exert
excessive force with tools.