Yamaha NS-C103 Owner's Manual

Yamaha NS-C103 Manual

Get Yamaha NS-C103 PDF manuals and user guides View all Yamaha NS-C103 manuals
Add to My Manuals
Save this manual to your list of manuals

Yamaha NS-C103 manual content summary:

  • Yamaha NS-C103 | Owner's Manual - Page 1
    NS-C103 Natural Sound Center Speaker System Thank you for selecting this Yamaha NS-C103 speaker system. PRECAUTIONS Read these precautions carefully before using your speaker. ● Any time you note distortion, reduce the volume control on your amplifier to a lower setting. Never allow your amplifier
  • Yamaha NS-C103 | Owner's Manual - Page 2
    TV or on the floor under the TV or inside the TV rack in a stable position. Speaker on TV TV set SPECIFICATIONS Type 2-way 3-speaker bass-reflex speaker system Magnetic-shielding type Speaker Unit 8 cm cone woofer x 2 2.2 cm semi-dome tweeter Nominal Impedance 6 ohms Frequency Response 65 Hz
  • 1
  • 2
NS-C103
Thank you for selecting this Yamaha NS-C103 speaker system.
PRECAUTIONS
Read these precautions carefully before using your speaker.
●
Any time you note distortion, reduce the volume control on
your amplifier to a lower setting. Never allow your amplifier to
be driven into “clipping”. Otherwise the speaker may be
damaged.
●
When using an amplifier with a rated output power higher than
the nominal input power of the speaker, care should be taken
never to exceed the speaker’s maximum input.
●
Do not attempt to clean the speaker with chemical solvents as
this might damage the finish. To clean, wipe with a dry, soft
cloth.
●
To prevent the enclosure from warping or discoloring, do not
place the speaker where it is exposed to direct sunlight or
excessive humidity.
●
Do not place the speaker where it is liable to be knocked over
or struck by falling objects. Stable placement will also ensure
better sound performance.
●
Placing the speaker on the same shelf or rack as the turntable
can result in feedback.
●
Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident caused by
improper placement or installation of the speaker.
BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE
AMPLIFIER IS SWITCHED OFF.
■
CONNECTIONS
●
Connect the push-type input terminals at the rear of the
speakers to the speaker output terminals of your amplifier with
the provided speaker cables.
●
One side of the speaker cable is red and the other side is
black. Connect the (+) terminals on both the amplifier and the
speakers using this red side. Connect the (–) terminals on both
components using the black side of the cable. If connected
with reversed polarity, the sound will be unnatural and lack
bass.
Procedures:
Press the tab on the terminal down, as shown in the figure.
Insert the bare wire end properly into the terminal hole.
[Remove approx. 10 mm (3/8”) insulation from the speaker
cable.]
Remove your finger from the tab to allow it to lock snugly on
the cable’s wire end.
Check the connection by lightly pulling the cable at the
terminal.
Note
Do not let the bare speaker wires touch each other as this
could damage the speaker and/or the amplifier.
CONNECTION TO YOUR AMPLIFIER
Natural Sound Center Speaker System
Press
tab
Center speaker output
terminals of the amplifier
Red
NS-C103
Black
Red
Red
Red
Amplifier