Yamaha NS-E103 Owner's Manual
Yamaha NS-E103 Manual
 |
View all Yamaha NS-E103 manuals
Add to My Manuals
Save this manual to your list of manuals |
Yamaha NS-E103 manual content summary:
- Yamaha NS-E103 | Owner's Manual - Page 1
Sound Bass-Reflex Effect Speaker System Thank you for selecting this Yamaha NS-E103 speaker system. PRECAUTIONS Read these precautions carefully before using your speaker. ● Any time you note distortion, reduce the volume control on your amplifier to a lower setting. Never allow your amplifier - Yamaha NS-E103 | Owner's Manual - Page 2
long mounting For side-long mounting Wall or wall support Fasten wood screws onto a firm wall or wall support as shown in the figure, and set the loose speaker cables, fix them to the wall. SPECIFICATIONS Type Full-range bass-reflex speaker system Magnetic shielding type Speaker Unit 10 cm cone
-
1 -
2
 |
 |
NS-E103
Thank you for selecting this Yamaha NS-E103 speaker system.
PRECAUTIONS
Read these precautions carefully before using your speaker.
●
Any time you note distortion, reduce the volume control on
your amplifier to a lower setting. Never allow your amplifier to
be driven into “clipping”. Otherwise the speaker may be
damaged.
●
When using an amplifier with a rated output power higher than
the nominal input power of the speaker, care should be taken
never to exceed the speaker’s maximum input.
●
Do not attempt to clean the speaker with chemical solvents as
this might damage the finish. To clean, wipe with a dry, soft
cloth.
●
To prevent the enclosure from warping or discoloring, do not
place the speaker where it is exposed to direct sunlight or
excessive humidity.
●
Do not place the speaker where it is liable to be knocked over
or struck by falling objects. Stable placement will also ensure
better sound performance.
●
Placing the speaker on the same shelf or rack as the turntable
can result in feedback.
●
As some speaker contain strong magnets, avoid placing
watches, magnetic tapes, etc. near them. Also, placing
speaker near a TV set may impair picture color. If this
happens, move the speakers away from
the TV set .
●
Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any
accident caused by improper placement or installation of
the speaker.
BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE
AMPLIFIER IS SWITCHED OFF.
■
CONNECTIONS
●
Connect the push-type input terminals at the rear of the
speakers to the speaker output terminals of your amplifier with
the provided speaker cables.
●
One side of the speaker cable is marked with a gray line.
Connect the
(+) terminals on both the amplifier and the
speakers using this gray-marked side. Connect the (–)
terminals on both components using the unmarked side of the
cable.
●
Connect one speaker to the left (marked L) terminals of your
amplifier, and another speaker to the right (marked R)
terminals, being sure not to reverse the polarity (+, –). If one
speaker is connected with reversed polarity, the sound will be
unnatural and lack bass.
Procedures:
Press the tab on the terminal down, as shown in the figure.
Insert the bare wire end properly into the terminal hole.
[Remove approx. 10 mm (3/8”) insulation from the speaker
cable.
Remove your finger from the tab to allow it to lock snugly on
the cable’s wire end.
Check the connection by lightly pulling the cable at the
terminal.
Note
Do not let the bare speaker wires touch each other as this
could damage the speaker and/or the amplifier.
CONNECTION TO YOUR AMPLIFIER
R
L
Natural Sound Bass-Reflex Effect Speaker System
Red
Press
tab
Black
Speaker (R)
Gray line
Gray line
Speaker output
terminals of
the amplifier
Speaker (L)
Gray line
Amplifier