Yamaha NS-P270 Owner's Manual

Yamaha NS-P270 Manual

Yamaha NS-P270 manual content summary:

  • Yamaha NS-P270 | Owner's Manual - Page 1
    UB NS-P270/ NS-P276 (NS-P270 / NS-P276: NX-E270 + NX-C270 + SW-P270) OWNER'S MANUAiL
  • Yamaha NS-P270 | Owner's Manual - Page 2
    servicing) instructions in the literature accompanying the appliance. IMPORTANT Please record the serial number of this system in the space below. Model: Serial No.: The serial number is located on the rear of the unit. Retain this Owner's Manual -P270. • Do not place the following objects on SW-P270
  • Yamaha NS-P270 | Owner's Manual - Page 3
    instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by YAMAHA try to eliminate the problem using one of the YAMAHA Corporation of America or its subsidiaries. For U.K. customers If the socket outlets in the home letter N or coloured BLACK. The wire which
  • Yamaha NS-P270 | Owner's Manual - Page 4
    owner's responsibility. YAMAHA is not liable for accidents caused by improper placement or installation of speakers speakers. Contact qualified YAMAHA service personnel when service is needed. The cabinet should never ve opened for any reason. 13 Be sure to read the "Troubleshooting test speaker system
  • Yamaha NS-P270 | Owner's Manual - Page 5
    connection example 6 Connecting speaker cables 7 Connecting components and the subwoofer to AC power 7 Using the subwoofer (SW-P270 8 Pre-adjusting the subwoofer volume 8 Advanced YAMAHA Active Servo Technology (on the SW-P270 9 Troubleshooting 10 Specifications 11 Frequency characteristics
  • Yamaha NS-P270 | Owner's Manual - Page 6
    a YAMAHA NS-P270 or NS-P276 Home Cinema 5.1/6.1 Channel Speaker System. Each of these systems includes the following speakers: • NX-E270 The NX-E270 are full-range acoustic-suspension speakers. Each system includes two (2) front and two (2) surround speakers. In addition, the NS-P276 system includes
  • Yamaha NS-P270 | Owner's Manual - Page 7
    Surround back speaker (for NS-P276 systems only): Position the surround back speaker behind your listening position, precisely between the surround speakers, about 1.8 m (approx. 6 feet) above the floor. You can set the front, surround, and surround back speakers on tables or other supports, or mount
  • Yamaha NS-P270 | Owner's Manual - Page 8
    below. Peel off the seal. Positioning the subwoofer (SW-P270) It is recommended to place it on the outside of either the right or the left front speaker. (See fig. A.) The placement shown in fig. B is also possible, however, if the subwoofer system is placed directly facing the wall, the bass effect
  • Yamaha NS-P270 | Owner's Manual - Page 9
    You can place the front and surround speakers (and surround back speaker in an NS-P276 system) on a shelf or rack, set them on the floor, or mount them on a wall or speaker stand. To mount the speakers on a wall: 1. Affix screws to a firm wall or wall support as shown below. (Use tapping screws
  • Yamaha NS-P270 | Owner's Manual - Page 10
    only after you complete all other connections. Basic connection example Front speakers Right Left Surround speakers Right Left Note: The rear panel of various amplifiers may differ in appearance. Amplifier Subwoofer To AC outlet 6 Center speaker Surround back speaker (in NS-P276 systems)
  • Yamaha NS-P270 | Owner's Manual - Page 11
    at the terminal. Black: negative (-) Red: positive (+) Note: Do not insert 1 the insulation coating 2 into the hole. The sound may not be 3 produced. Connections: • Connect the front, center and surround speakers (and surround back speaker for the NS-P276) to the speaker output terminals on
  • Yamaha NS-P270 | Owner's Manual - Page 12
    Using the subwoofer (SW-P270) 2 VOLUME 1 3 INPUT 4 POWER ON OFF Rear panel 1Power indicator the entire sound system using the amplifier's volume control. • If you replace the front speakers (NX-E270) with other speakers, you must again balance the subwoofer and surround speaker volume. • For
  • Yamaha NS-P270 | Owner's Manual - Page 13
    P270) The theory behind YAMAHA Active Servo Technology is based on two factors: the Helmholtz resonator and negative-impedance drive. Active Servo Processing speakers reproduce the bass frequencies through an "air woofer," which is a port or opening in the speaker speaker system This problem is
  • Yamaha NS-P270 | Owner's Manual - Page 14
    Troubleshooting Refer to the chart below if the unit does not function properly. If the problem you are experiencing is not listed, or if the instructions fail to help you resolve the problem, disconnect the power cord and contact your authorized YAMAHA dealer or service center. No sound. Problem
  • Yamaha NS-P270 | Owner's Manual - Page 15
    P270 subwoofer combined with NX-E270 speakers. 100 dB 90 VOLUME 80 70 60 50 40 20 SW-P270 NX-E270 50 100 200 500 Hz NX-E270/NX-C270 Type .........Full-range acoustic-suspension speaker system kg
  • Yamaha NS-P270 | Owner's Manual - Page 16
    ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

NS-P270/
NS-P276
(NS-P270 / NS-P276:
NX-E270 + NX-C270 + SW-P270)
OWNER’S MANUAL
UB