Yamaha PF-800 PF-800 OWNERS MANUAL

Yamaha PF-800 Manual

Get Yamaha PF-800 PDF manuals and user guides View all Yamaha PF-800 manuals
Add to My Manuals
Save this manual to your list of manuals

Yamaha PF-800 manual content summary:

  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 1
    ASSEMBLING THE TURNTABLE AND TONEARM . . , . MOUNTING THE CARTRIDGE MOUNTING THE HEADSHELL ADJUSTING THE TONEARM BALANCE STYLUS ADJUSTING THE CARTRIDGE TRACKING FORCE ADJUSTING THE ANTI-SKATING FORCE TONEARM HEIGHT ADJUSTMENT STYLUS HEIGHT ADJUSTMENT MOUNTING THE DUST COVER CONNECTIONS
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 2
    normally or exhibits a marked change in performance; or E. The appliance has been dropped, or the cabinet damaged. 1 6 Servicing - The user should not attempt to service the appliance beyond those means described in the operating instructions. All other servicing should be referred to qualified
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 3
    THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER- SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION: READ THIS PE:FORE OPERATING YOUR PF•8OO The PF-800 is a sophisticated semi-automatic belt-drive turntable. To assure proper operation for the best
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 4
    YAMAHA 2F -B00 3 0 LIFTER ADJUSTMENT The PF-800 tonearm is equipped with an optical non-contact detector and auto-lift function. Refer to "LIFTER ADJUSTMENT" on page 9. ® TRACKING FORCE KNOB Refer to "ADJUSTING THE CARTRIDGE SWITCH This is used to select the turntable speed. When playing a 33-1/3
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 5
    loose, replace it with a replacement belt. ACCESSORIES Fig.1 Headshell 2 Strobe disklclamper lO1 (ol Cartridge mounting parts 2 Belt ...1 Allen wrench .. YAMAHA Main weight .. 1 45 adaptor 1 Overhang gauge ... 1 Dust cover hinges CAUTION Replacement belt .. 1 Inner platter Center shaft Motor
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 6
    from 2 to 11 grams may be used with this turntable. 1. Properly connect the headshell leads to the pins on the cartridge. 2. Loosely mount the cartridge to the headshell with the cartridge mounting screws. Mounting the cartridge Blue (-L) Green (-R) 3. Align the stylus with the accessory overhang
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 7
    the arm rest, PF-800 r ADJUSTING THE CAR .fRIDGE STYLUS TRAGKING FORGE Be careful not to move the main weight after making the balance adjustment. Turn the tracking force knob to align with the specified stylus pressure of the cartridge used. Balance adjustment Headshell is too heavy. (Rotate
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 8
    the adjustment screw so the distance from the stylus to the record is 6 mm. Adjustment screw O Loosen.ip Tight Stylu down Arm lifter C) Stylus up Cartridge N rL? 6 mm 01 Headshell Record Fig. 7 Fig. 8 Fig. 9 7
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 9
    the turntable speed by using the strobe disk, first set the speed switch to either 33-12/ or 45. Next turn the speed control until the striped band corresponding to the electrical frequency used in your area appears to not move . 60-33-V3 50-33-12/ 60-45 50-45 YAMAHA 0 PF
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 10
    PF-800 LIFTER ADJUSTMENT The PF-800 tcnearm is equipped with an optical non-contact detector To move automatic lift position inward. ° ADJUSTMENT OF THE FLOATING PANEL Remove the three suspension covers, and then, as shown in the figure, the forward/backward, left/right and heightadjustment of
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 11
    the cueing switch (refer to page 3) to interrupt record play. PF-800 SPECIFICATIONS Ei TURNTABLE MOTOR Drive System Motor Turntable Platters Inner Outer Turntable Moment of inertia Speeds Signal-to-Noise Ratio Wow and Flutter Belt drive FG Servo DC motor Zinc, 0.86 kg (1.9 lbs.) Aluminum
  • Yamaha PF-800 | PF-800 OWNERS MANUAL - Page 12
    PF-800 TROUBLESHOOTING Before assuming that the turntable is defective. check the following troubleshooting list which details the corrective actions you can take yourself without having to call a service engineer. If you have any doubts or queries, please contact your nearest YAMAHA dealer. Fault
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
YAMAHAPF-E3
Thank
fur
purcim.
,
,etiz
the
MAI
t
rrit.
CONTENTS
CAUTION
NAMES
OF
DARTS
AND
THEIR
FUNCTIONS
.....
ASSEMBLING
THE
TURNTABLE
AND
TONEARM
. .
,
.
4
MOUNTING
THE
CARTRIDGE
5
MOUNTING
THE
HEADSHELL
5
ADJUSTING
THE
TONEARM BALANCE
6
ADJUSTING
THE
CARTRIDGE
STYLUS
TRACKING
FORCE
6
ADJUSTING
THE
ANTI
-SKATING
FORCE
.
.
.
.
. .
..
..
.
.
....
.....
..
7
TONEARM
HEIGHT
ADJUSTMENT
7
STYLUS
HEIGHT
ADJUSTMENT
7
MOUNTING
THE
DUST
COVER
8
CONNECTIONS
TO
YOUR
AMPLIFIER
8
STROBE
DISK
8
LIFTER
ADJUSTMENT
9
ADJUSTMENT
OF
THE
FLOATING
PANEL
9
PLAYING
RECORDS
10
SPECIFICATIONS
10
TROUBLESHOOTING
11
Natural
Sound
Belt
-Drive
Turntable
Three
-Point
Floating
Suspension
Two,Section
Zinc
Plus
AlimainuM
Platter
Dynamic
Balance
TwinLPipe
Tonearm
Aptomatic
Atm
Lifter
With
UniqueDi$c
Clamp
NTER
OWNER'S
MANUAL
IMPORTANT!
Please
record
the
serial
number
of
your
unit
in
the
space
below:
Model:
PF-800
Serial
No.:
The
serial
number
is
located
on
the
rear
of
the
chassis.
Retain
this
Owner's
Manual
in
a
safe
place
for
future
reference.
WARNING
To
prevent
fire
or
shock
hazard,
do
no
expose
this
appliance
to
rain
or
moisture.
'.:skA,
6