Yamaha PSR-9000 Owner's Manual - Page 57

Organ Flutes Vibrato Depth Footage Volume Mode Attack Length Response Reverb Depth Chorus Depth DSP on/off DSP Depth Vibrato Speed DSP Type Slow/Fast EQ Low EQ High Can be set to any of three levels via the Vibrato Depth LCD button. The button sequentially selects a depth of "1", "2", or "3". The footage settings determine the basic sound of the organ flutes. The term "footage" is a reference to the sound generation of traditional pipe organs, in which the sound is produced by pipes of different lengths (in feet). The longer the pipe, the lower the pitch of the sound. Hence, the 16' setting determines the lowest pitched component of the voice, while the 1' setting determines the highest pitched component. The higher the value of the setting, the greater the volume of the corresponding footage. Mixing various volumes of the footages lets you create your own distinctive organ sounds. Adjusts the overall volume of the Organ Flutes. The longer the graphic bar, the greater the volume. The MODE control selects between two modes: FIRST and EACH. In the FIRST mode, attack is applied only to the first notes played and held simultaneously; while the first notes are held, any subsequently played notes have no attack applied. In the EACH mode, attack is applied equally to all notes. The ATTACK controls adjust the attack sound of the ORGAN FLUTE voice. The 4', 2 2/3 ' and 2' controls increase or reduce the amount of attack sound at the corresponding footages. The longer the graphic bar the greater the attack sound. The LENGTH control affects the attack portion of the sound producing a longer or shorter decay immediately after the initial attack. The longer the graphic bar the longer the decay. The Response control affects both the attack and sustain portion of the sound, increasing or decreasing the response time of the initial swell and release, based on the FOOTAGE controls. The higher the value the slower the swell and release. For details about the digital effects, see page 123. Determines the speed of the vibrato effect controlled by the Vibrato On/Off and Vibrato Depth above. Determines the DSP effect type to be applied to the Organ Flutes voice. Normally this will be one of the six available Rotary Speaker effects. If any other type of effect is selected the Rotary SP Speed LCD button in the main ORGAN VOICE editing display will not control rotary speaker speed. Instead, it will have the same effect as the VOICE EFFECT [SLOW/FAST] button. Slow/Fast Determines whether the DSP variation (Slow/Fast) will be set to Slow or Fast when the Organ Flutes voice is selected (when the Voice Set function is ON - page 139). Value Sets the DSP variation (Slow/Fast) parameter value (e.g., "LFO Freq" for a Rotary Speaker effect) when the DSP variation (Fast) is turned on. The EQ parameters determine the Frequency and Gain of the Low and High EQ bands. q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q Reference 57 55