Yamaha QY700 Owner's Manual - Page 138

5. Velocity 6. Pitch Bend 7. Control Change • The VELCTY box lets you select whether or not to display velocity values on the point graph. If you choose to display these values, they are indicated by a symbol that appears directly under the start point of each note. The scale runs vertically from 1 (at the bottom) to 127 (at the top). • The P.BEND box lets you select whether to display pitchbend values on the point graph. If you choose to display these values, they are indicated by a symbol. The scale runs from -8192 (bottom) to +8191 (top), with the center of the graph (the dashed line) corresponding to 0. • The point graph will only display one type of control-change event. You use the CONTRL box to select the type, as well as to enable or disable the display. You enable/disable the display by setting or removing the checkmark. You select the event type by entering the control-change number: for example, 001 to show modulation-wheel events, or 011 to display expression events. Occurrences of the selected control change event are indicated on the graph by the symbol. The scale (for the control change argument) runs from 0 (bottom) to 127 (top). 0101 1101 To display on point graph: To suppress from graph: Control change number : #001,...,#031,#033,...,#119 1. Press d [D2], d [D3], or d [D4] to move the cursor into the checkmark area of the VELCTY, P.BEND, or CONTRL box. 2. Use n/y or the data dial to set or remove the checkmark. 3. To change the control-change number: Press d [D4] once or twice to move the cursor to the numbersetting area. Set the number using n/y or the data dial. Chapter 2. SONG MODE 6. Song Editing 2 137