Yamaha QY700 Owner's Manual - Page 147

7. Song Jobs 2. Segment and notes (M and Note=) • The two boxes at the top of the screen (to the right of the M) select the track segment over which adjustment is carried out. The first box sets the measure and beat for the start point; the second box sets the end point. The Note boxes select the range of notes (pitches) to be targeted by the adjustment: notes with pitches outside this range are not affected. 0101 1101 Measure: beat Note range 001:1,...,999:8 C-2,...,G8 3. Set all • Use this parameter if you want to set the velocities of all targeted notes to the same fixed value (1 to 127). If you do not want to use this feature (if you want to make the linear adjustment instead), set the value to Off. • Note that if the setting is other than Off, the Rate and Offset values are ignored. 0101 1101 Off (0), 001,...,127 4. Rate • The Rate parameter applies a proportional change to the velocities of all targeted notes. A setting of 100% produces no change; a setting of 50% cuts the velocities in half; a setting of 200% causes the velocities to double. Original velocities 5. Offset • This parameter adds a fixed value to each of the Rate-adjusted velocity values. A setting of 0 produces no change. Positive values increase the velocity, while negative values decrease it. Original velocities (Vel) 96 64 32 127 96 Offset = -20 (Vel) 76 44 12 Offset = +20 (Vel) 116 84 52 0101 1101 -99,...,+00,...,+99 107 76 127 116 (Vel) 96 64 32 127 96 Rate = 50% (Vel) 48 32 16 63 48 Rate = 150% (Vel) 127 96 48 127 127 0101 1101 000%,...,100%,...,200% 146 Chapter 2. SONG MODE