Yamaha QY700 Owner's Manual - Page 268

Job 10 Shift Event 7. Pattern Jobs • This job replaces all occurrences of a specified event type (within the selected segment of the selected phrase) with some other designated event type. Although the event type itself is replaced, its accompanying argument (parameter value) is retained and applied to the new event type. • As an example, you can use this function to change every breath-controller event into a channel-aftertouch event, while leaving the magnitude of the event unchanged. 1. Phrase • The Phrase value selects the user phrase. 0101 1101 01,...,99 2. Segment • The two boxes to the right of the M select the phrase segment over which the substitutions are executed. 0101 1101 Measure:beat 001:1,...,256:8 3. Source event • The two boxes at the center select the event type to be replaced. 0101 1101 CC 001,...,031,033,...,127 Control-change event CAT Channel aftertouch PB MSB Pitch bend MSB Note Note event (where the note- Note (Velo=64) number argument is re- tained.) Note Note event (where the ve- Velo# (Note=C3) locity argument is retained.) 4. Destination event • The two boxes at the bottom select the event type that replaces the "source" event. 0101 1101 CC 001,...,031,033,...,127 Control-change event CAT Channel aftertouch PB MSB Pitch bend (With the LSB argument set to 00.) Note Note (Velo=64) Note event (where original 5 argument gives the new note number; velocity is set to 64; and gate time is set to 108.) Note Note event (where original Velo# (Note=C3) argument gives the new ve- locity; the new note becomes C3; and gate time is set to 108.) Chapter 5. PATTERN MODE 267