Yamaha QY700 Owner's Manual - Page 296
Sequencer
View all Yamaha QY700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 296 highlights
4. Sequencer 4. Sequencer u 1 System 2 MIDI 3 MIDI filter 4 Sequencer 5 Click 6 Fingered chord zone F1 F2 F3 F4 F5 F6 • Here are the setup parameters for the sequencer block. 1. Press u. w The indicator located above u will light, and you will enter Utility mode. 2. Press4 (Seqencr) to access the Sequencer page. 3. Move the cursor to the parameter that you wish to set. 4. Use n/y, the data dial, or numeric keypad → e to set the value. 1. Mute tracks level • This setting specifies how much the volume (velocity) will be reduced when a track is muted. • This setting will also affect the other tracks that are muted when a track is soloed. 0101 1101 Off, 01% - 99% Off There will be no sound. 01% - 99% The velocity values will be reduced by the specified percentage. The muted volume will be (original veloc- ity) x (mute track setting). 2. Event chase • Event Chase is a function that rapidly plays back the specified types of event when a song, pattern, or phrase is played back from the middle or when it is rewound or fast-forwarded. This ensures that voice selections and pitch changes etc. will be correct for the location when playback begins. • If a song or phrase which uses program changes or pitch bend changes is played back from the middle or is rewound or fast-forwarded, the playback may use unexpected voices or the wrong pitch. Such problems can occur if the section of the song or phrase that was skipped over contains events such as program changes or pitch bends. • If the Event Chase function is used, the specified type(s) of 6 event will be played back at high speed from the beginning whenever a song or phrase is played back from the middle. This will mean that a certain length of time may elapse from the moment the Start command is given until playback actually begins, or that the rewind/fast-forward speed will be slower. • If Event Chase is set to ALL, large amounts of MIDI data will be transmitted from the MIDI OUT connector, which can cause MIDI errors to occur on the external MIDI device that is receiving this data. 0101 1101 Off, PC, PC,PB,Ctrl, ALL Off Event Chase will not be performed. PC Program Change messages PC,PB,Ctrl Program Change, Pitch Bend, and Control Change messages ALL All events other than notes Chapter 6. UTILITY MODE 295