Yamaha RXV465 Owner's Manual - Page 50
APPENDIX, Troubleshooting, General
UPC - 027108933214
View all Yamaha RXV465 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
APPENDIX Troubleshooting Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service center. General Problem Cause Remedy This unit fails to turn on or enters the standby mode soon after the power is turned on. This unit cannot be turned off. No sound. The power cable is not connected or the plug is not completely inserted. Connect the power cable properly to an AC wall outlet. The speaker impedance setting is incorrect. Set the speaker impedance to match your speakers. (When this unit is turned back on and "CHECK SP WIRES!" is displayed.) The protection circuitry has been activated because this unit was turned on while a speaker cable was shorted. Make sure that all speaker cables between this unit and speakers are connected properly. The internal microcomputer is frozen due to an external electric shock (such as lightning or excessive static electricity) or by a drop in power supply voltage. Disconnect the power cable from the AC wall outlet, wait about 30 seconds and then plug it in again. "Audio" in "1 HDMI" of Function Setup Select a choice for "Audio" (Function is set to "TV." Setup→1 HDMI→Audio) other than "TV." A proper audio decoder is not selected. Display the OPTION menu and set "Decoder Mode" to "Auto." Incorrect input or output cable connections. No appropriate input source has been selected. Connect the cables properly. If the problem persists, the cables may be defective. Select an appropriate input source with NINPUT l / h or the gInput selection keys on the remote control. Speaker connections are not secure. Secure the connections. The volume is turned down or muted. Turn up the volume. Signals this unit cannot reproduce are being input from a source component, such as a CD-ROM. Display Signal info of the option menu and check the input signal format. If "No Signal" is displayed, check if the playback component is properly connected to this unit (or a proper input source is selected). If "___" is displayed, the input signal in that format cannot be reproduced by this unit. The HDMI components connected to this unit do not support the HDCP copy protection standards. Connect HDMI components that support the HDCP copy protection standards. See page - 45 11 - 42 33 14-16 21 11 - - 55 46 En