Yamaha RXV465 Owner's Manual - Page 51
English, INTRODUCTION, APPENDIX, PREPARATION, BASIC, OPERATION, ADVANCED, substantial sound. - troubleshooting
UPC - 027108933214
View all Yamaha RXV465 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
INTRODUCTION PREPARATION BASIC OPERATION Troubleshooting Problem No picture. The sound suddenly goes off. Sound is heard from the speaker on one side only. Only the center speaker outputs substantial sound. No sound is output from a specific speaker. No sound is heard from the surround speakers. Cause Remedy See page An appropriate video input is not selected Select an appropriate video input on the monitor. - on the monitor. The composite output terminals are used If your monitor does not support the HDMI 14 to output a component video signal, or the connection, connect it to the COMPONENT OUT COMPONENT VIDEO jacks are used to jacks or the composite output terminals and select an output a composite video signal. appropriate video input on the monitor. Non-standard video signals are input. Connect the monitor to this unit via the 14 COMPONENT OUT jacks or the composite output terminals. The protection circuitry has been activated Check that the speaker impedance setting is correct. 45 because of a short circuit, etc. Check that the speaker wires are not touching each - other and then turn this unit back on. The sleep timer has turned off this unit. Turn on this unit, and play the source again. - The playback component or speakers are Connect the cables properly. If the problem persists, 11 not connected properly. the cables may be defective. The speaker level settings are incorrect. Adjust "B)Level" settings. 41 When a monaural source sound field Try another sound field program. 24 program is applied, sound of all channels are output from the center speaker for some surround decoders. Output from that speaker is disabled. Check the Speaker indicators on the front panel display. If the corresponding indicator is turned off, try the following. 1) Change the input source to another one. 2) With the selected sound field program, sound is not output from that speaker. Select another sound field program. 3) "None" may have been selected for that speaker on this unit. Display Speaker Setup in the Setup menu and enables output of that speaker. 6, 21, 24, 40 The volume of that speaker is set to Display Speaker Setup in the Setup menu and adjust 41 minimum in Speaker Setup in the Setup the volume (Manual Setup→B)Level). menu. This unit or speaker is malfunction. This unit is in the "STRAIGHT" mode and a monaural source is being played back. Check the Speaker indicators on the front panel display. If the corresponding indicator lights up, connect another speaker and check if sound is output. If sound is not output, this unit may be malfunction. Press LSTRAIGHT or the jSTRAIGHT on the remote control to turn off the "STRAIGHT" mode. 6, 10 27 Sound may not be output from certain Try another sound field program. 24 channels depending on input sources or sound field programs. ADVANCED OPERATION APPENDIX English 47 En