Yamaha RXV465 Owner's Manual - Page 55
Bluetooth™, Auto Setup (YPAO), Before Auto Setup, During Auto Setup - bluetooth pairing
UPC - 027108933214
View all Yamaha RXV465 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION Problem Unable to play Bluetooth™ Cause This unit cannot play back the songs currently stored on your iPod. Troubleshooting Remedy Check that the songs currently stored on your iPod are playable. Store some other playable music files on your iPod. See page - - Problem Searching... Completed Canceled BT Connected BT Disconnected Cause The Bluetooth wireless audio receiver and the Bluetooth component are in the middle of the pairing. The Bluetooth wireless audio receiver and the Bluetooth component are in the middle of establishing the connection. The pairing is completed. The pairing is canceled. The connection between the Yamaha Bluetooth wireless audio receiver and the Bluetooth component is established. The Bluetooth component is disconnected from the Yamaha Bluetooth wireless audio receiver. Auto Setup (YPAO) Remedy See page Notes • If the "ERROR" or "WARNING" message appears, resolve the problem and then run "Auto Setup" again. • Warning message "W-2" or "W-3" indicates that the adjusted settings may not be optimal. • Depending on the speakers, warning message "W-1" may appears even if the speaker connections are correct. • If error message "E-10" occurs repeatedly, contact a qualified Yamaha service center. Before Auto Setup Error message Connect MIC! Unplug HP! Memory Guard! Cause Remedy Optimizer microphone is not connected. Headphones are connected. The parameters of this unit are protected. Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel. Unplug the headphones. Set "Memory Guard" to "Off." During Auto Setup See page 18 - 43 Error message E-1:NO FRONT SP E-2:NO SUR. SP E-4:SBR->SBL Cause Remedy Front L/R channel signals are not detected. Only a signal from one of the surround channels are detected. Only right surround back channel signal is detected. Check the front L/R speaker connections. Check the surround L/R speaker connections. If you connect only one surround back speaker, connect it to the L-side (SINGLE) terminal. See page 11 11 11 APPENDIX English 51 En