Yamaha S710 Firmware upgrade - Installation for PSR-S910/S710 EN

1

Version 1.10 Upgrade Manual

Version 1.10 of the firmware adds the following functionality to PSR-S910 and PSR-S710 models.

• Support for the Wi-Fi Protected Access (WPA) wireless encryption standard (with the exception of certain

USB-LAN adaptors

*1

)

•

*2

(with the exception of certain USB-LAN adaptors

*1

)

• Support for the following USB-LAN adaptors.

Wireless:

Buffalo WLI-UC-GN

Buffalo WLI-UC-GNHP

Planex GW-USMicroN

Planex GW-USMini2N

Edimax EW-7711UAn

Edimax EW-7711UTn

Hawking HWUN3

Tenda W311U

Belkin F6D4050

LogiLink WL0049A

LogiLink WL0054

Wired:

LINKSYS USB300M

AIRLINK101 ASOHOUSB 10/100Mbps Fast Ethernet USB 2.0 Adapter

macally AIR2NET

INTELLINET Hi-Speed USB 2.0 to Fast Ethernet Adapter

*

1: For more details, please visit the Yamaha Piano / Keyboard website (below) and refer to the list of USB devices confirmed as

working with our products. http://music.yamaha.com/download

*2:

For more details, please refer to the Internet Connection Guide, which can be downloaded from the Yamaha Manual Library

website.

1.

Turn on the PSR-S910/S710.

This can be done by pressing the [STANDBY/ON] switch

located at the left of the front panel.

2.

Confirm the instrument’s current firmware

version as follows.

2-1

Press the [FUNCTION] button.

2-2

Press the [J] (UTILITY) button.

2-3

Using the TAB [

E

] / [

F

] buttons, select the OWNER tab

and display the Owner setting screen.

2-4

Press the [7

▲

] (VERSION) button to display the current

firmware version. If the displayed version number is less

than 1.10, the firmware should be upgraded.

2-5

Press the [8

▲

] (EXIT) button or the [EXIT] button to close

the window.

3.

Turn off the PSR-S910/S710.

This can be done by pressing the [STANDBY/ON] switch

located at the left of the front panel.

To upgrade the firmware, place the upgrade data on a USB flash

memory device and then carry out the upgrading procedure as

described below.

1.

Plug the USB flash memory device containing

the upgrade data into the PSR-S910/S710.

2.

Hold down the [START/STOP] button and press

the [STANDBY/ON] switch.

Continue to hold down the [START/STOP] button until the

following message is displayed.

3.

Install the upgrade data.

To do so, release the [START/STOP] button and then press

it once again.

Confirming the Current Version

Upgrading the Firmware

DIGITAL WORKSTATION

/