Yamaha SGV Owner's Manual

Yamaha SGV Manual

Yamaha SGV manual content summary:

  • Yamaha SGV | Owner's Manual - Page 1
    ELECTRIC GUITAR OWNER'S MANUAL 4(74&3*&4 4(7γϦʔζ
  • Yamaha SGV | Owner's Manual - Page 2
    Congratulations on your purchase of the YAMAHA electric guitar. With reasonable care, your YAMAHA electric guitar will age gracefully and provide many years of superlative musical service. CARE AND MAINTENANCE * When connecting or disconnecting cables, turn off the amplifier and other equipment or
  • Yamaha SGV | Owner's Manual - Page 3
    SGV800 Nomenclature Front P.U. Rear P.U. 3-P P.U. Selector SW. Front P.U. Front P.U. + Rear P.U. Rear P.U. Front P.U. Volume Rear P.U. Volume Master Tone 3
  • Yamaha SGV | Owner's Manual - Page 4
    Pickup A Pickup B Pickup C 4 SGV700/SGV300 Nomenclature 3-P P.U. Selector SW. Pickup A Pickup A+(B+C)* Pickup (B+C)* * The balance of pickup (B+C) depends upon the position of the Pickup Fader Control. Master Volume Master Tone Pickup Fader Control: Adjusts the output balance of pickups B and C.
  • Yamaha SGV | Owner's Manual - Page 5
    Adjustment Procedure Make sure guitar is tuned to pitch before making adjustments to the truss rod. The curvature of the neck should be slightly concave. The practice of sighting down the neck to see whether there is a bow or bend is unreliable, and even experienced bass technicians can be misted
  • Yamaha SGV | Owner's Manual - Page 6
    the strings and frets. Changing this setting will change the manner in which the guitar plays. If the string height is too high, it will be difficult to play, it will cause fret buzz. 1. Loosen the strings. 2. Use the supplied box wrench to remove the anti slip nut on the 1st string and 6th
  • Yamaha SGV | Owner's Manual - Page 7
    Bridge Saddle of SGV 300/800 Electric Guitars The bridge saddles may lift off of the bridge plate from intonation adjustments or vibration while transporting. To adjust the saddles, loosen the strings and
  • Yamaha SGV | Owner's Manual - Page 8
    with the harmonic tone at the 12th fret. Tune so that both pitches are the same. It is recommended that you use good quality strobe tuning scope for this function. * Please use the supplied Allen wrench to adjust the octave adjustment screw. • If the pitch of the note played on the 12th
  • Yamaha SGV | Owner's Manual - Page 9
    's angle (adjustment of the amount of floating) will be necessary. 1. Remove the four (4) cover fixing screws located on the back side of the guitar body and remove the cover. Tail section Adjust the height uniformly 2. Adjust the two (2) spring screws uniformly, so as to maintain good balance
  • Yamaha SGV | Owner's Manual - Page 10
    Adjust the Arm Tension Use the tension adjustment screw, located on the side of the tail piece, to adjust the tension that holds the tremolo arm in place. Insert the
  • Yamaha SGV | Owner's Manual - Page 11
    SERVICE If your guitar should need any parts or service, or if you need any information, including the address of your nearest YAMAHA dealer, contact: YAMAHA CORPORATION OF AMERICA Guitar Service Department 6600 Orangethorpe Avenue Buena Park, Calif. 90620 Calif. U.S.A. TEL: 714 522 9433 YAMAHA
  • Yamaha SGV | Owner's Manual - Page 12
    QC55690 R1 0004 Printed in Taiwan
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

ELECTRIC GUITAR
OWNER’S MANUAL
エレクトリックギター
オーナーズマニュアル
SGV SERIES
SGV シリーズ