Zanussi ZWG6141P Product Manaul

Zanussi ZWG6141P Manual

Get Zanussi ZWG6141P PDF manuals and user guides View all Zanussi ZWG6141P manuals
Add to My Manuals
Save this manual to your list of manuals

Zanussi ZWG6141P manual content summary:

  • Zanussi ZWG6141P | Product Manaul - Page 1
    EN User manual Washing Machine ZWG 6141 P
  • Zanussi ZWG6141P | Product Manaul - Page 2
    wash programmes the door spare parts. Installation • This appliance is heavy. Care should be taken when moving it. • All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual
  • Zanussi ZWG6141P | Product Manaul - Page 3
    other than those for which it was designed. • Only wash fabrics which are designed to be machine washed. Follow the instructions on each garment label. • Do not overload the appliance. See the "Washing Programme Chart". • Before washing, ensure that all pockets are empty and buttons and zips
  • Zanussi ZWG6141P | Product Manaul - Page 4
    device and restore the possibility of closing the door, rotate the button anti-clockwise until the hose from the tap; 4. unscrew the drain hose from the rear support and unhook it from sink or spigot; 6. let the drain hose council, your household waste disposal service or the shop where you purchased
  • Zanussi ZWG6141P | Product Manaul - Page 5
    of laundry being washed. 1 2 3 7 11 8 9 4 9 5 6 1 Detergent dispenser drawer 2 Worktop 3 Control panel 4 Door opening handle 5 Rating plate (on the inner edge) 6 Front adjustable feet Technical data Dimensions Width Height Depth 7 Water drain hose 8 Drain hose support 9 Hose holders 10
  • Zanussi ZWG6141P | Product Manaul - Page 6
    Load Spin Speed Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door. Minimum Maximum 0,05 MPa 0,8 MPa Cotton 6 kg Maximum 1400 rpm Installation Unpacking Warning! • Read carefully the "Safety information" chapter before installing
  • Zanussi ZWG6141P | Product Manaul - Page 7
    • Open the door and remove the plastic hose guide, the bag containing the instruction booklet and the plastic plug caps from the drum. Warning! Do not remove the drain hose from the rear support. Remove this hose only if it is necessary to drain the water. Refer to "Frost precaution" and "What to
  • Zanussi ZWG6141P | Product Manaul - Page 8
    and stable. Water inlet Connect the hose to a tap with a 3/4" thread. Firstly form a hook in the end of the drain hose using the plastic hose guide supplied with the appliance . The end of the drain hose can be positioned in four ways: • Hooked over the edge of a sink using the plastic
  • Zanussi ZWG6141P | Product Manaul - Page 9
    If your drain hose looks like this (see beside) you do not require the "U" piece". Just push the hose firmly in to the standpipe. MAX 100cm Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose to prevent waste from the sink entering the appliance.
  • Zanussi ZWG6141P | Product Manaul - Page 10
    replace or modify the mains cable yourself. Contact the After Sales Service. • Make sure that the mains plug and cable is not wash code symbols on each garment label and the manufacturer's washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. machine
  • Zanussi ZWG6141P | Product Manaul - Page 11
    long tapes. Remove any hooks (e.g curtains). • Never wash whites and coloureds together. Whites may lose their «whiteness» in the wash. • New coloured items may run in the first wash; they should therefore be washed separately the first time. • Rub particularly soiled areas with a special detergent
  • Zanussi ZWG6141P | Product Manaul - Page 12
    , cottons, etc.), the colour, washing temperature and degree of soiling. All commonly available washing machine detergents may be used in this appliance suggest you to add a water softener following always the manufacturer's instructions. When the degree of hardness is soft, readjust the quantity
  • Zanussi ZWG6141P | Product Manaul - Page 13
    wash before starting the wash programme. Warning! use liquid detergent if the washing programme doesn't start immediately wash programme. Close the detergent dispenser drawer Set your washing programme The control panel permits to select a washing washing programmes and options, see the "Washing
  • Zanussi ZWG6141P | Product Manaul - Page 14
    another programme when the appliance is working, the red pilot light of the button 6 will flash 3 times to indicate a wrong selection. The appliance will not perform the new selected programme. • To switch the temperature button to select the most suitable temperature for washing your laundry . 14
  • Zanussi ZWG6141P | Product Manaul - Page 15
    is not emptied out to prevent the fabrics from creasing. Before opening the door it will be neces- sary to empty out the water. To empty the paragraph «At the end of the pro- gramme». 4 Super Quick Super Quick By pressing this button the corresponding pilot light illuminates. Short cycle for
  • Zanussi ZWG6141P | Product Manaul - Page 16
    , Indicator pilot lights . 7.1 7.2 7.3 Important! The selected delay can be changed only after selecting the washing programme again. The door will be locked throughout the delay time. If you need to open the door, you must set the appliance to PAUSE (by pressing the button 6) and then wait a few
  • Zanussi ZWG6141P | Product Manaul - Page 17
    Washing programmes Door seal At the end of every cycle, check from the door seal White and coloured cotton. This programme can be selected for slightly or normally soiled cotton items. The temperature will decrease and the washing time will be extended. This allows to obtain a good washing QUICK
  • Zanussi ZWG6141P | Product Manaul - Page 18
    Machine washable wool, hand washable woollens and delicate fabrics with «hand washing» care symbol. Note: A single or bulky item may cause imbalance. If the appliance doesn't perform the final spin phase, add more items, redistribute the load manually REDUCTION RINSE HOLD SUPER QUICK 1) EXTRA RINSE
  • Zanussi ZWG6141P | Product Manaul - Page 19
    up. AUTOMATIC SPIN REDUCTION DELAY START JEANS 60°- Cold Main wash - Rinses - Maximum spin speed at 1200 rpm Max. START 1) If you select the SUPER QUICK option by pressing button 5, we recommend consumption (litre)1) Programme duration (Minutes)1) White Cottons 90 °C 2.1 78 175 Cottons 60
  • Zanussi ZWG6141P | Product Manaul - Page 20
    consumption for washing that Wash With the use of low temperature washes all washing powder residue. • Clean all the removed parts of part of the additive compartment should be removed. After having cleaned the dispenser and the drawer recess, replace it. Cleaning the drain filter The filter
  • Zanussi ZWG6141P | Product Manaul - Page 21
    • turn the drum and align the filter cover (FILTER) with the arrow on the door seal; • open the filter cover by pressing the special hook and by rotating the cover upwards; Warning! Keep the filter cover open until the filter removal. • before removing the filter, remove any fluff or small objects
  • Zanussi ZWG6141P | Product Manaul - Page 22
    working. Before contacting your local Service Centre, please carry out the filter in the inlet hose or the inlet valve filter are blocked • Clean the water inlet filters (read "Cleaning the water inlet filters" for more details). The light of button 6 flashes and the light 7.2 illuminates: Problem
  • Zanussi ZWG6141P | Product Manaul - Page 23
    filter support support and reposition it; - Open the door and remove the laundry; - Carry out the drain filter cleaning as described in "Cleaning the drain filter"; - At the end of cleaning action, close the door Door open The door has not been closed or is not closed properly. • Close firmly the door
  • Zanussi ZWG6141P | Product Manaul - Page 24
    or inlet hose is damaged. • Replace it with a new one. The programme is still running. The door will not open: • Wait the end of washing cycle. The door lock has not been released. • Wait until the door lock is released. There is water in the drum. • Select drain or spin programme to empty out
  • Zanussi ZWG6141P | Product Manaul - Page 25
    the drum. This may happen several times before the unbalance disappears and normal more items, redistribute the load manually and then select the spinning treated prior to washing. Unsatisfactory washing results • Use , contact your Service Centre. The necessary data for the service centre is on
  • Zanussi ZWG6141P | Product Manaul - Page 26
    26
  • Zanussi ZWG6141P | Product Manaul - Page 27
    27
  • Zanussi ZWG6141P | Product Manaul - Page 28
    www.zanussi.com/shop 192987540-A-102011
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
EN
User manual
Washing Machine
ZWG 6141 P